Network Security

************************Kindly look on the configuration and guide me please.************************interface GigabitEthernet0/0 nameif outside security-level 0 ip address 10.10.10.2 255.255.255.252 !interface GigabitEthernet0/1 nameif Inside securi...

Hi all,kindly any one can tell me how i can extended ping in ASA. i am not getting any option to ping with source IP in ASA.Thanks

Dear all,We had purchase SSL VPN License.Could some one push me in right direction, how to install SSL VPN License in ASA5550.much appricate.thanks & regards,

Hi.Is there a way of having a single Public IP address and NAT'ing to 2 different IP addresses. Either loads balanced or one as primary and the second in the event of failure??Basically I would like to do the simplest job of the CSS on an ASA.To be h...

Hi guys,I'll start a project with two ASA5510 for redundancy, also come with CSC-SSM-20 as contect filering. In the CSC SSM administrator guide, it mentioned the SSM support Windows AD integration to •Identify the user roles •Apply group HTTP acc...

Hi AllI have a ASA 5510, I have configure 2 VPN, router 850-ASA is OK, but I can't establish the other VPN ASA-Astaro, the error is:Jul 09 15:35:57 [IKEv1]: Group = 200.50.2.114, IP = 200.50.2.114, QM FSM error (P2 struct &0x3bcd8c0, mess id 0x4f4f1e...

Hi all,I have a question about why signatures are enabled or disabled by default. I can understand that something like echo reply is disabled, because it could cause too many events, and is informational only. But a significant number of high-risk si...

Hi!Is it possible to find out why and when a host was included in the "denied attackes" list?Paulo Roque

I'm having some trouble with h.323 (video) calls through a PIX 525 using NAT. We can get incoming calls fine, but not outgoing calls for some reason. My question has to do with 'inspect h323' vs 'fixup protocol h323'. What's the difference between th...

Dears,is there any way to deploy Cisco Aironet Access Points in OOB on NAC appliance without using a WLC such as VLANs configuration on Access-points via Radius Server or any other way?Thanks

Dear friends,On the 6500 switches, we have an option to give interface level commands like ""no ip unreachables", "no ip redirects", "no ip accounting access-violation"".Is there a FWSM equivalent command for this?Thanks a lotGautam

i'm using pix firewall and using it as a firewall and as a proxy server, the problem is that i can't block the web access from the clients that installed on their pcs a program named ultrasurf , this program changes the web proxy setting in the inter...

Hey Everyone,I've run into a problem and I can't tell if it's a "you can't really do that" type or the brain-fart type.We are starting to test out the AAA cut-through-proxy feature to see if it can satisfy some access requirements we have. I have the...

We are going to have 10 remote sites connect to us for a L2L VPN to access data at our location. We have no control over the remote sites, and my guess is most will br 192.168.1.x IP range. How can we make this work?? Remember, I have no control over...