Network Security

I have set up a ipsec/ike vpn on my cisco pix ( 515E), ASDM version is 5.2(3), PIX version is 7.2(1) and enable IPSec over NAT-TWhen the VPN connection authenticate the user via TACAC+, it works great...however, now I try to set it up so that it will...

PIX 501 connected to a residential cable modem. Speedtests are giving me 3mbit down. When I plug a machine into the cable modem I am getting 10-12mbit.Posting pertinent info:interface ethernet0 autointerface ethernet1 100fullnameif ethernet0 outside ...

Is it good to install CSA on a Cisco LMS server?If yes, is there any downloadables policies from cisco about CiscoWorks LMS?Thank you

Dear All,I have ASA 5520 and AIP-SSM20 withASA Version : Version 8.0(4) AIP-SSM20 version: 6.2(1)E3Signature Definition: Signature Update S365.0 2008-10-31 Virus Update V1.4 2007-03-02 I want to update my signature and virus detaisl with uptodate.how...

Hi,Is CSA 6.0 client compatible with MsWindows 2008 serverBest regards

After installing CSA 6.0.0.209 on Win2003 Server,the cluster service is not started.The server said that the network connection service is not started.The CSA is registered in the Management Center.And the group is in LEARN MODE.What is the source of...

I am trying to setup a dmz to talk to my internal network and the internal network to talk to the dmz. Any ideas

How can I implement a mac address filter on a particular vlan on an ASA 5505? I want only a couple of machines to be able to plug in and use the ASA.Thanks!

Trying to setup start before logon to initiate vpn connection prior to logging into windows. The issue I am having is I can select a profile and connect, but the user authentication screen pop is missing the text boxes for username and password. They...

"show conf" command on my AIP SSM CLI. gigabitEthernet0/1 backplane interface of the SSM has not been assigned to virtual sensor vs0.butThrough this command show service-policy traffic is recevied by IPS Module.why this,Kindly guide me

Hi All, we plan to implement two ASA 5510 as passive and active failover with AIP-SSM IPS. is it possible to configure two AIP-SSM as failover as well? How can I implement two AIP-SSM in two ASA with failover capability? if it's not possible, what's ...

Hi allI have a rare problem with some TCP connections from inside to outside. I get a TCP reset in two cases, one of them is when i try to download from the internet a fig file (crashes at few seconds) and the other is a https stock exchange service ...

Hi,I'm having issues with static identity NAT on an ASA 5505.We use VLAN 2 for the outside interface and VLAN1 for the inside. The outside WAN is connected to Eth 0/0 and the inside to Eth 0/1. Then we have created 1 to 1 static identity NAT statemen...

Hi expert, I would like to set up a remote access VPN service for my work at home, the basic settings are worked and I can remote to the subnet in my company. However, I can not explore to other hosts by the hostnames. In fact I need to do it because...

Hi folks,is there a way of issuing a command to tell you what switch you are on when you are logged into the FWSM ie if switch name is SW1 and the FWSM is FWSM1. How would I know that I'm on SW1?