Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

What is the internal value of the Attack Relevancy Rating for the system with relevance=not-relevant. I do not see any difference for the system with relevance=unknown. In the attachment you will find the example of an attack? It is OK or not?Looking...

k.dmowski by Frequent Visitor
  • 824 Views
  • 2 replies
  • 0 Helpful votes

Resolved! NAT RESERVATION

Hi,A windows server is connected to a modem and has a public ip address. 2 others public ip addresses are reserved on the server (but not assigned to physical interfaces)such that these addresses are translated into private addresses on other servers...

kolawole1 by Level 5
  • 836 Views
  • 2 replies
  • 0 Helpful votes

Hello all,I have a question in a test environment, mount the topology as the attached file, and inserting the wing route to 172.16.2.0/24 via 192.168.0.10 network the ping command works, but any protocol that is oriented to connect does not work. Mon...

r-barbosa by Level 3
  • 1864 Views
  • 6 replies
  • 0 Helpful votes

I've got an ASA with multiple interfaces on it. I've got an inside,outside, dmz1, dmz2,and dmz3. I have a static NAT for a server in the DMZ to a global inet address on the outside via:static (dmz1,outside) 210.x.x.10 192.168.1.1I have a server in dm...

mjsully by Level 5
  • 1310 Views
  • 1 replies
  • 0 Helpful votes

I'm investigating an issue with an application that uses "connection pooling". Basically it creates a number of connections at start-up and and then uses them as required. What I think is happening is that as the connections are idle until used, they...

Thank you so much for taking the time to help. I have been tasked to configure a VPN failover design so that if the customer's Metro Ethernet connection fails, (EIGRP not in route table) a VPN connection will initiate autmatically. The Remote site wi...

johnaceti by Level 3
  • 1111 Views
  • 3 replies
  • 0 Helpful votes

Hi,When you configure the second ASA should it have a different hostname, or just different IP addresses. I currently have the failover working but if it does failover the secondary will keep the primary hostname when reverting back. Also if i set an...

Review Cisco Networking for a $25 gift card