Network Security

Hi all,I have a Cisco 2811 with IOS Version 12.4(20)T and I need to enable IPS or IDS in this. What is the config for this?First of all, I need to know whether I can do IPS/IDS in my router as well..- Ribin

we are MPLS service provider, we need to deploy new services that when our customer bursting above the CIR we need to charge them for that bursting , we have CE to PE links like 10 M, SO so we are not using dial up or dsl links between the CE and PE ...

HelloWhen will the ASA 5505 support the IPS Feature?Thanks and RegardsLuke

Hi, Is it possible to check the failover date and time on ASA. 'show failover' command only shows the state change without any date/time information.

OK, here is my scenario: I have one internal client which must be accessed externally, so I have setup an external address. Now we have several remote sites, this particular server resides in our North Carolina office. The site has its own internet c...

I am trying to get Passive FTP working on my PIX.I have Active FTP, SFTP, HTTPS, and FTPS (both explict and implicit) working.In order to get directory transfers to work I have to specify the external IP address to present in PASV on my FTP server, s...

Hello, We have two ISPs providing the two separate links. But my IPS is having only one in port and one port. But I want both the ISP links should come to my LAN through IPS. How can I do? Can I do this. A switch has 2 L3 vlans, one vlan for incoming...

Hi allI need to log any external attack to the ASA. To do this i have issued the folowing commands:logging enablelogging timestamplogging buffer-size 100000logging buffered warningsaccess-list acl-out extended deny ip any any log warningsThe problem ...

Hi,I have a site-to-site VPN setup with a client on pur PIX. The tunnel is currently using the default group policy, so access is only permitted to the customer servers. I would like to grant the customer site http access to one of our internal serve...

Hi,I have Mail server in the DMZ zone,and it is natted and the port 25 is opened....with the following command,When I try to telnet the server NATTED ip with the port 25 ,I am getting the blank screen,but no message appears....static (dmz,outside) tc...

Hello All,I have managed to get my ASA5505 to authenticate IPs for cut though proxy using Telnet and it works great.However I want to use only Telnet for authentication and if a user has not yet authenticated and then opens a browser session they are...

Hi to all,I'm new at NAC, does anyone know the steps on how to configure the remediation on a client machine using NAC and WSUS?? Is there a rule that match it??, etc, etc...Thanks in advance for your help!

Hi, If the SSM module is rebooted in a ASA failover configuration, would the ASA failover take place. Is it possible to avoid failover upon SSM failure.