Same old story, but I've been unable to resolve. Client that we've recently taken over with 501 to 506 VPN but can't access LAN resources from one side to the other. (Ping, browse, telnet...). Both configs attached. Thanks in advance.
Hi, I have opened the following ports between our OWA server in the DMZ and our LAN (80, 691, 389, 3268, 88, 53, 135 and 1024 and above) as per this article http://www.msexchange.org/tutorials/owa_exchange_server_2003.html. My question is what securi...
Hi All,I have a request to allow SMTP access from the outside world to my 'inside' LAN. Try as I may I just cannot seem to allow access through on port 25. Port 110 (POP3) is working fine just not 25!! I have no fixup going on and SMTP is working fin...
hello security people, help me to find answer to my security question.here is the problem: i have cisco 6506 , 48 gig. interfaces and 9 SFP,and one firewall module. one SFP interface is connected to the ISP, and gigethernet to small offices. there is...
I've just reconfigured my pix 515e.When I assign a global address, I get an error "Warning: Start and End addresses overlap with broadcast address."Not sure what it means... Is it saying the address assigned to the WAN is a broadcast address for the ...
Hi need expert help, can Cisco pix 515 translate a single public ip to multiple internal IP? I need to redirect let us say smtp traffic to one private ip and http traffic to another private ip listening from the same public ip. Can this be done? Is t...
Hi, I recently tested QoS over an IPSEC tunnel using and 876 and was able to limit effective input and output rates using QoS on the router between two hosts.This got me thinking about trying it on an ASA. I have tried this on an ASA with no success,...
how can i check my For License Renewals
I have an ASA5510 at a remote location. I used the IPSec VPN Wizard to configure Remote Access for the developers into the DMZ portion of the network, 192.168.100.0/24.I can connect using both the latest Cisco client on Windows and using VPNC on my L...
Has anyone had issues where guest users would come into your company network to VPN out to their own company network but is not able because the return traffic back to that user comes back as ESP instead of IP?
Hi, one of inside user are not able to connect with servers through remote VPN. And when I use clear xlate command then it works but after some time same issue happens. After inspection the logs then I found the following error.regular translation cr...
At first i configure my asa 5520 8.0 to vpn with 3des encryption but now i want aes encryptionWhen i set new crypto isakmp policy & transform-set it's not working and i see in debug this:IKEv1]: Group = x.x.x.x, IP = x.x.x.x, QM FSM error (P2 struct ...
Hi I have a Cisco ASA 5540 that I have numerous lan-to-lan VPN's. According to one of our IT analysts, they primarily use the tunnel from midnight to 7am. Outside of that time frame they say the tunnel goes down. Should I increase the timeout on my s...
Since the performance of a given physical firewall between an active active pair can vary dramatically depending where the two contexts are, what might be some general approaches regarding monitoring (HPOV or MARS or SYSLOG) and properly detecting da...
Hi all - I was hoping to get a few experienced eyes on my config. I am having problems connecting to the internet from the internal vlans. Any ideas?Also, I am trying to setup dhcp on both vlan2 (private) and vlan3 (guest) however only the vlan2 (pri...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 11-06-2026 12:20 AM | ||
| 09-22-2026 04:13 PM | ||
| 08-25-2026 06:22 PM | ||
| 08-24-2026 12:26 AM | ||
| 08-20-2026 05:54 AM |
| User | Count |
|---|---|
| 2 | |
| 1 | |
| 1 | |
| 1 | |
| 1 |
