Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello, I currently have set up a VPN Concentrator 3000 series. I use RADIUS to authenticate users and the concentrator acts as a DHCP server and issues IP's to users who connect to our network. Currently some users can connect and access all required...

ttuisawau by Level 1
  • 998 Views
  • 3 replies
  • 0 Helpful votes

Hi All, Need some assistance in ASA 5540 with OS 7.2 as a DHCP Server. I have created subinterfaces on the firewall. I want the firewall to act as a DHCP Server which assigns different ip addressess to different vlan (Voice, Video & Data). Is this po...

hi all, A customer needs to enable ICMP for a public IP with different internal servers... I have following configuration on a ASA 5520static (inside,outside) tcp public_IP https 192.168.100.76 https netmask 255.255.255.255static (inside,outside) tcp...

Hi,Hope that someone can shed some light on the issue which I think is a problem. I am trying to configure the ASA firewall behind a 3800 router and the default route for the firewall is pointing to the router (via public IP).After I had configured a...

Dear ALL,Our Cisco IPS (all 3 of them) are not getting configuration updates. When Itry to apply them, they say they are successfully applied, but no changesare taking place on them. When I look at the log files I see the followingmessage.Jupiter2: D...

HiI am new to these devices and I am struggling to get the device configured and would very much welcome some help!For some reason I cannot give external users access to the web server in the dmz. The syslog is showing a block request everytime. At t...

garycollis by Community Member
  • 504 Views
  • 1 replies
  • 0 Helpful votes

Hi Sir,I ask question about session of ASA.I want to access from my host to Destination host.Example. +------------------+ | Destination host | +---+--------------+ | +---+----+ | Router | +---+----+ | Other network | | +---+----+ +-----+ | Switch |-...

Resolved! PIX Configuration

Could someone review my config? I need all traffic to flow accross the tunnel from one network to the next. I believe my access list and crypto map is right.

rmwhite59 by Level 2
  • 649 Views
  • 1 replies
  • 0 Helpful votes