Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About Rejohn Cuares
Stats
Member since
11-05-2006
271
Posts
116
Helpful
23
Solutions
Created by
Rejohn Cuares
in IP Telephony and Phones
in IP Telephony and Phones
05-20-2019
04:04 PM
05-20-2019
04:04 PM
This does not answer your question but follow this guides to successfully integrate the VG to CUCM. https://www.cisco.com/c/en/us/support/docs/voice/skinny-call-control-protocol-sccp/211575-CUCM-Auto-Configuration-for-SCCP-Gateway.html https://community.cisco.com/t5/collaboration-voice-and-video/stcapp-how-to-configure-fxs-ports-on-cucm/ta-p/3142555
... View more
Created by
Rejohn Cuares
in Other Collaboration Subjects
in Other Collaboration Subjects
04-18-2018
11:04 PM
04-18-2018
11:04 PM
I confirmed that the Extension Mobility over MRA on version x8.10.4 is fixed and validated using 88XX phones.
... View more
Created by
Rejohn Cuares
in IP Telephony and Phones
in IP Telephony and Phones
04-17-2018
04:39 PM
04-17-2018
04:39 PM
I'd say monitor this through RTMT and if it is gradually increasing then there is something wrong.
... View more
Created by
Rejohn Cuares
in IP Telephony and Phones
in IP Telephony and Phones
03-26-2018
06:06 PM
03-26-2018
06:06 PM
Anther option is to call your telephony provider and ask them to block international country for you.
... View more
Created by
Rejohn Cuares
in IP Telephony and Phones
in IP Telephony and Phones
03-26-2018
06:02 PM
03-26-2018
06:02 PM
For on-demand recording, you can use the Cisco Unity Connection live recording which I believe would satisfy your requirement.
I have use CallReplay. It is simple to setup and integrate. The only problem I had was the support due to big gap in timezone.
... View more
Created by
Rejohn Cuares
in IP Telephony and Phones
in IP Telephony and Phones
03-26-2018
04:27 PM
03-26-2018
04:27 PM
I installed version 11.5SU4 of CUCM for couple of customers and I never encountered this kind of problem.
... View more
Created by
Rejohn Cuares
in IP Telephony and Phones
in IP Telephony and Phones
03-20-2018
11:23 PM
03-20-2018
11:23 PM
This is more on your dial plan.
Check the calling party transformation mask and called party transformation mask in CUCM.
Login to CUCM and navigate to Call Routing > Transformation > Transformation Pattern.
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/11_0_1/sysConfig/CUCM_BK_C733E983_00_cucm-system-configuration-guide/configure_transformation_patterns.pdf
... View more
Created by
Rejohn Cuares
in Other Collaboration Subjects
in Other Collaboration Subjects
03-20-2018
08:43 PM
03-20-2018
08:43 PM
This feature is introduced in JFW version 1.8 and there is no option to hide this.
Contact your Cisco representative and tell them your use case.
The only option I could think is only provision IMP functionality to the user. It means no telephony features at all.
... View more
Re: Expressway-E and public IP
in Other Collaboration Subjects
03-20-2018
08:33 PM
03-20-2018
08:33 PM
Place the Exp-E in DMZ and either assign the public IP directly to the application (Exp-E) or 1-to-1 NAT. Both of them are common deployment option and will work. I typically use the two-arm deployment option (i.e. dual-NIC). This is to avoid NAT reflection issue with the firewall.
Link: https://www.cisco.com/c/en/us/support/docs/security/ios-network-address-translation-nat/212392-configure-nat-reflection-on-the-asa-for.html
... View more
Created by
Rejohn Cuares
in Other Collaboration Subjects
in Other Collaboration Subjects
03-20-2018
08:23 PM
03-20-2018
08:23 PM
Jabber installer is distributed as MSI. You could try the below.
"For MSI installers there is a perfect debugging tool named ORCA (One Really Cool Application). It is part of Microsoft PLatform SDK (or Windows SDK). The tool can export all tables stored inside MSI database. Every table in MSI is basically a list of instructions describing the intended change on target machine."
Link: https://superuser.com/questions/457860/how-can-i-find-out-what-modifications-a-program-s-installer-makes
There are other applications mentioned in the forum that you could try as well. Good luck!
... View more
Created by
Rejohn Cuares
in IP Telephony and Phones
in IP Telephony and Phones
03-20-2018
06:36 PM
03-20-2018
06:36 PM
Refer to these similar posts.
https://supportforums.cisco.com/t5/unified-communications/cucm-how-to-lower-disk-usage-on-partitions/td-p/2983240
https://supportforums.cisco.com/t5/unified-communications/high-disk-usage-of-active-partition-on-cucm-after-upgrade/td-p/3074977
http://docwiki.cisco.com/wiki/Troubleshooting_DiskSpace_and_Partition_related_alerts
HTH.
... View more
Created by
Rejohn Cuares
in IP Telephony and Phones
in IP Telephony and Phones
03-20-2018
06:30 PM
03-20-2018
06:30 PM
Conference Now uses the MeetMe function. Cisco documentation says that it can support up to a maximum of 128 participants. However, I would say that this number is subject to UC deployment options which has different vCPU and vRAM allocations (i.e. 1000 users, 2500 users, etc.). This is true if your using the CUCM's software conference resource. You could probably get the maximum (128 participants) if you would use hardware conference resource.
HTH.
... View more
Created by
Rejohn Cuares
in IP Telephony and Phones
in IP Telephony and Phones
03-20-2018
06:17 PM
03-20-2018
06:17 PM
There is a tech note published on this. Refer to this link.
https://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-system/115749-analyze-pcm-data.html
You can also try Switch made by NCH Software.
... View more
03-20-2018
06:09 PM
This can be done using these Cisco IOS tools. I have used this and it works.
1. EEM
- EEM is used to update the configuration of the IPSec peer.
2. DDNS
- DDNS is used to publish its new IP do DynDNS.
- Reference: Refer to https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipaddr_dns/configuration/15-mt/dns-15-mt-book/dns-dyn-dns-supp-ios.html#GUID-89BCB212-EE5C-40D9-AEF5-B18DDB5D5758
Cisco also published a tech note on this kind of setup.
https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-architecture-implementation/118048-technote-ipsec-00.html
Please be aware that for the 4G/LTE, the IP address that is allocated by the IPS is a private IP address and the ISP does the NAT. This is what I noticed in my country anyway, not sure in other parts of the world. Thus, make sure the your 4G/LTE provider assigns public IP address instead of private IP address.
HTH.
... View more
03-20-2018
05:49 PM
I would suggest posting this kind of question to Cisco Learning Networks.
https://learningnetwork.cisco.com/welcome
I'd probably provide these links as they are informative references. Happy reading.
http://blog.ine.com/2010/04/25/how-well-do-you-know-vtp/
https://learningnetwork.cisco.com/search.jspa?q=vtp
https://www.youtube.com/results?search_query=vtp
https://www.cisco.com/c/en/us/support/docs/lan-switching/vtp/10558-21.html
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/31sg/configuration/guide/vtp.html
... View more
Created by
Rejohn Cuares
in IP Telephony and Phones
05-20-2019
05-20-2019
This does not answer your question but follow this guides to
successfully integrate the VG to
CUCM.h...
Created by
Rejohn Cuares
in Collaboration Applications
05-20-2019
05-20-2019
First is to start collecting logs on the failed node in the cluster.
Then go through the logs and se...
Created by
Rejohn Cuares
in Other Collaboration Subjects
04-18-2018
04-18-2018
I confirmed that the Extension Mobility over MRA on version x8.10.4 is
fixed and validated using 88X...
Created by
Rejohn Cuares
in IP Telephony and Phones
04-17-2018
04-17-2018
I'd say monitor this through RTMT and if it is gradually increasing then
there is something wrong.
03-26-2018
Anther option is to call your telephony provider and ask them to block
international country for you...
03-26-2018
For on-demand recording, you can use the Cisco Unity Connection live
recording which I believe would...
Created by
Rejohn Cuares
in IP Telephony and Phones
03-26-2018
03-26-2018
I installed version 11.5SU4 of CUCM for couple of customers and I never
encountered this kind of pro...
Created by
Rejohn Cuares
in IP Telephony and Phones
03-20-2018
03-20-2018
This is more on your dial plan. Check the calling party transformation
mask and called party transfo...
Created by
Rejohn Cuares
in Other Collaboration Subjects
03-20-2018
03-20-2018
This feature is introduced in JFW version 1.8 and there is no option to
hide this. Contact your Cisc...
03-20-2018
Place the Exp-E in DMZ and either assign the public IP directly to the
application (Exp-E) or 1-to-1...
Created by
Rejohn Cuares
in Other Collaboration Subjects
03-20-2018
03-20-2018
Jabber installer is distributed as MSI. You could try the below. "For
MSI installers there is a perf...
Created by
Rejohn Cuares
in IP Telephony and Phones
03-20-2018
03-20-2018
Refer to these similar posts.
https://supportforums.cisco.com/t5/unified-communications/cucm-how-to-...
Created by
Rejohn Cuares
in IP Telephony and Phones
03-20-2018
03-20-2018
Conference Now uses the MeetMe function. Cisco documentation says that
it can support up to a maximu...
Created by
Rejohn Cuares
in IP Telephony and Phones
03-20-2018
03-20-2018
There is a tech note published on this. Refer to this link.
https://www.cisco.com/c/en/us/support/do...
Public Statistics
| Date Registered | 11-05-2006 11:36 PM |
| Date Last Visited | 03-04-2020 12:17 AM |
| Total Messages Posted | 271 |
| Total Helpful Votes Received | 116 |
Helpful Votes Given To
| User | Helpful Count |
|---|---|
| 5 | |
| 5 | |
| 5 | |
| 5 | |
| 5 |
.jpg "VIP Advisor"){kind=icon}
Helpful Votes From
| User | Helpful Count |
|---|---|
| 5 | |
| 5 | |
| 5 | |
| 5 | |
| 5 |
