Network Security

Does anyone know of a good PIX auditing tool? I did a search and found the one by Algosec (still pending) and tried a RAT that had PIX functionality built in with no luck. I setup VMS 2.3 with the MC 1.3.6 and maybe I'm lost but I saw no auditing cap...

Hi !I have a probleme with a card csc-ssm on a ASA5520.I've put the url filtering enable . i choose some subjets to filter like games and porno. The card stop the games site but dont't block any porno site.i get the site url and put it on the Trend M...

Hi,I want to analyze traffic logs of cisco 2600. But I am getting only denied syslogs as below.<190>162384: Nov 22 22:12:48: %SEC-6-IPACCESSLOGP: list IN denied udp xxx.xxx.xxx.xxx(123) -> yyy.yyy.yyy.yyy(20), 5 packetsI have enabled "ip inspect audi...

Hi All,We need your assistance Issue: VPN Pkts get dropped. 1) A Site-to-Site VPN is established b/w Checkpoint & Cisco PIX. 2) Often the connectvitiy Flaps, i.e. the pkst get dropped.Error:Pix: Duplicate pkt on Phase 2Checkpoint: Virtual defragmenta...

We have cat 6509 switch with FWSM, IDSM-2, NAM modules. Customer wants all the internal VLAN's to be monitored by IDSM in inline mode. Customer has around 400 VLANS in datacenter and wants to monitor all communications between VLAN's. How do I monito...

What is the recommended minimum Cisco IOS Software that will support Cisco IPS Sensor Software v6 on the CAT6509

HI,I have an ASA 5520 with AIP-SSM10, I have configure AIP module with setup, but I dont have access through the ASDM to IPS, I only have access through cli session 1 comand.How can I acces the module through the ASDM.

We're configuring a firewall with 3 interfaces - inside, DMZ & outside and are trying to figure out what is the typical traffic flow for a firewall..Does the packet that enters from the outside, first goes out the DMZ interface, where the destination...

I am a newbie to the Pix. I am trying to understand the running config list. The question I have is what does the command line mean:access-list inside-outbound deny tcp 10.1.2.0 255.255.255.0 any eq 135Does it mean deny TCP 135 traffic from outbound ...

dear guys help in pix 525 configurationi have pix525 with active /standby license what i have to doand right now i cant ping from my inside of pixfirewall to dmzzonei cant understandi appliend nat ,global,acces-list still its not pinging my secanrion...

I'm moving from a Pix515e Failover set to an ASA5520 Failover set, and ending up with 2 less interfaces on the ASA. Is it a given that I should allocate 1 interface each for outside, inside, and failover - and then put all my DMZs on sub-interfaces o...

Hi,I am trying to find out if I can configure an ASA 5510 to hold down 2 external WAN links for load balancing?If it could load balance itself it would be good or could I do something based on the inbound source IP's (i.e. ip's 192.168.20.1 to 20.100...