Network Security

I am trying to setup DDNS on my ASA 5505, since we are unable to get a static IP. I am trying to use no-ip.com. Has anybody been successful with setting this up on an ASA?

HiWe jhave a pair of redundant pix firewalls running 6.3 os.Last week we failed them over and all appeared well with the IP addresses swapping as expected, but we did have a loner that expected outage. This was approx 3 mins,, this was the time it to...

Hello,We are in the process of acquiring a 2nd ISP. We intend to in the future to use a load balancer to balance traffic between both ISP's. However the ISP has installed their service before the Load balancer has been purchased.I would thus like to ...

I currently have one ASA 5510 sitting behind one of my edge routers and I'd like to also use this same device to firewall another WAN link. Currently the 2 networks behind each WAN link can talk to each other through our core router. Is this doable? ...

I have two local and one global MARS system. All are 200'sI would like, for a short period of time, to degrade or change the global to a local....I know I have to purge the local controllers of Global stuff.QUESTION IS:When I re-image with the latest...

Is there a way to get a PIX to log what vpngroup is used when creating a VPN connection? Syslog is recording PIX-4-602301 when the SA is created but it doesn't say which group was used. I could even get what I needed if I knew what IP address the PIX...

What is required to allow a traceroute to go through the PIX firewall? I believe I have it setup correctly, but I'm still unable to trace through. It just times out when it gets to the firewall. Thanks.

My upstream provider is changing IP blocks. They are presenting both blocks to the current port our PIX 501 is hanging off of. I would like to be able to facilitate a smooth transition between IP Blocks, so I would like to have both blocks available ...

I'm trying to migrate from a PIX 515E to a ASA 5510. The PIX is running software version 7.2(2). How can I back up the config from the PIX, and upload to the ASA? I have been told that I need to convert the syntax to match the ASA, but I can't find a...

is their a way on the TrendMicro Interscan, for Cisco CSC SSM module, to white list a certain file so that it wont be scanned?I am currently running the CSC to inspect all of my traffic and i have encountered a problem when a remote vpn network conne...

I want to know is it possible to configure this firewall so that the inside and outside interface are configured on the gigabit port modules rather than on board ?Does anyone knwo if this is possible or any problems i may run into ?

HiI'm new at PIX configuration and have the following pb :I have 2 PIX connected via VPN LAN-to-LAN.Network_A behind PIX_A and network_B behind PIX_B can fully communicate.Then I want to prevent one PC (PC_A) from network_A to communicate with one PC...

When the IDSM-2 is in-line does it always perform IP/TCP normalization functions on all traffic (modify/drop/fragment re-assembly) even if I disable all of the normalization signatures?ThanksThomas

can anyone help me to configure IDS 4215 ?basic installtion and configuration Guide

Upgraded from FWSM 2.2 single routed context to FWSM 3.1.5, multiple context, transparent mode on 6513( Sup2 MSFC2 ver 12.2(18)SXF6), no ACLs on router. Number of Vlans and hosts didn't change. After the upgrade ping respons times to machines behind ...