Network Security

I have been tasked with swapping out two legacy PIX 515 E's with two recently purchased ASA 5510's.Is there any prerequisite information that I should be aware of, i.e., are there any special steps or things that I need to do to migrate to the new pl...

Does anyone know if it is possible for a PIX 515E to do simple Port Address Translation (PAT)? Also, how many concurrent connections that would sustain?Thanks,Johnny

My cert is coming up for renewal and I wanted to know if anyone knows a quick way of getting the CSR and renewing. I see the request CRL in the ASDM module but can find on doco on what that actually does. Last time I did this it was painful.

Hi all,Is there a show command for the IDSM2 module with version 5.1 that display a summary of the signatures (and if they are enabled or disabled) installed in the sensor?Regards

Hi,Actually , i will install the CSA software on a group of servers which are the following :-Antivirus server-Exchange server-ISA server-DNS & DHCP servers-file & print server-System management server (SMS).-Back serverI would like to ask you that i...

Hi. I'm after some advice. Is there any way to restrict the remote end of a site-to-site VPN connection to certain devices on our network? We use a Pix 515E (v7 s/w). I know how to do it for remote users connecting via Cisco client s/w but not for ex...

Does anyone know if there is/are any issue(s) after upgrading to ver. 7.2(2)?Many Thanks.

I've been waiting for CSM 3.1 since it's supposed to support IPS 6.x but the download section doesn't show 3.1 as an option. There is a patch for 3.1 but not the app itself. It sure sounds like it was available as there are people talking about it bu...

Hello,The PIXs are is FW2139 and FW2140. I am user "show failover" command, the PIX is below information.FW2139Failover On Cable status: NormalFailover unit PrimaryFailover LAN Interface: N/A - Serial-based failover enabledUnit Poll frequency 15 seco...

HI,Please guide me for the followingI have 2 PIX525 in failover mode.In the primary I have configured the followingfailoverfailover timeout ----secfailover poll --secfailover IP address inetrface 1 (Secondary PIX Interface IP address)failover IP addr...

I am running FWSM 2.3(3) and need to upgrade to 3.1(4). Booted maintenance partition to check version 2.1(2) requirement. I found that mp is up to date.After "hw-module module 1 reset", I cannot access the FWSm anymore. 6509-SW-01#sess slot 1 pro 1Th...

Hello,I've configured my 878 router as a PPTP VPN server. It works very fine and very quickly. Using the XP VPN client from a remote site, I can "see" all servers in my network.2 questions 1) When doing telnet on the 878 through the VPN, it is very s...

I need to upgrade 515E's from v6.x to the latest PIX IOS and firmware versions. I think that would be v 7.2 for the PIX IOS. Can anybody share beneficial knowledge from their experiences?Should I be concerned about the configurations when upgrading f...