Network Security

I want to test my IPS triggering an inbound IPS Sig event. Can anyone advise if Cisco has test attack files available to download for this purpose?Regards

I have an IPSEC between a pix 506 and an ASA5510. The tunnel is over DSL links and there is a problem with traffic not going through correctly. Initially I was trying to get a server remotely to join the domain across the VPN but this was timing out....

Can you NAT an internal IP to the external interface IP? I'm used to doing this on sidewinders but it's giving me an overlap errorThanks

Greetings allI have a question for anyone using any Cisco IDS products.How often the Cisco IDS/IDSM update it's signatures and are the updatescomparable to Snort? Example: An exploit is known...Snort publishes anupdate...can a similar update be found...

I have got two PIXs, Primary and SecondaryPrimary (192.168.1001.1) is StandbySecondary (192.168.1001.2) is ActiveWhen I try to access the PDM from primary (Standby) I could not, but I was able to access PDM for Secondary (Active)Secondary?s PDM Tools...

Any one can help me as how to configure in ASA as i have only one public IP address but i have to configure them for my two servers in my DMZ ... one is FTP and one is WEB server,,,,

When setting up the Stateful failover link, are there any issues if you use the management interface or should you only use an ethernet interface?

I have a pix with one static outside IP address and have been asked to forward a whole bunch of UDP and TCP to an internal (natted) IP address. I have done static mappings before but for only single port numbers. Below is the range of ports to forwar...

I have a PIX-506E set up locally and a PIX-506E set up at a Site 1. I can connect to Site 1 from my backup internet connection which isn't firewalled. When trying to connect to Site 1 through Local PIX I secure the communication tunnel.. but it will ...

Is there a way in the ASA to tell if it was started by a power up or by the reload command ? It doesn't show in the show version.Thanks

Hi, In cisco document http://cisco.com/en/US/customer/tech/tk648/tk362/technologies_tech_note09186a00807ca437.shtml#ios gives a table-2 showing the fixed version of PIX and ASA.Cisco PIX Platforms CSCse60554 Fixed in Version 6.3(6). Cisco Adaptive Se...

Cisco documentation indicates that PIX 6.3.6 will resolve daylight savings time issues. I don't believe PIX 6.3.6 is currently available for down load. Any ideas when 6.3.6 will be available?

we are new to the Cisco world, just set up our first ASA 5520 a couple weeks ago replacing another brand. Everything is fine except the internet connection seems to be slow. We tested outside the ASA and it was fine so it appears the ASA is the issue...

Hi,I have a Cisco 2801 router connected to the Internet running EasyVPN server and some site-to-site connections.Some of the clients from the EasyVPN server need to be able to 'use' the IP from the 2801 to access other servers in the public internet....

Can somebody give me a definitive answer preferably with a reference. On a PIX 525 E0 and E1 are clearly identified by markings on the chassis, however, if additional cards are added (i.e PIX-4FE-66 or PIX-1GE-66) how are the ports numbered? Do they ...