Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi,I am trying to using "Block ACLs" using IDS on a Cisco Router. After required configuration, I can see the IDS sensor logged into the router but no-preblock ACL gets configured. Thus also no Blocking occurs after the signature hit.There are no pre...

mnlatif by • Level 7
  • 969 Views
  • 3 replies
  • 0 Helpful votes

I get this warning when setting up site to site vpn using pdm 3.0 on pix 515 ver 6.3(4)[OK] isakmp key @############## address 66.45.80.156 netmask 255.255.255.255 no-xauth no-config-mode[OK] pdm location 10.128.174.128 255.255.255.224 outside[OK] pd...

dsdtnt1957 by • Community Member
  • 677 Views
  • 2 replies
  • 0 Helpful votes

We have an ASA5520 running V7.1(1).We are trying to set up the MAPI proxy feature for Outlook client connections to MS Exchange. In general, the WebVPN service is working OK, but we cannot connect Outlook via MAPI.Config:group-policy testvpn attribut...

Resolved! PIX_telnet

pls. help, i can ping my outside interface, how come i cannot telnet it, im just a novice, what command i need to add for my PIX firewall? thanks...

revilo3246 by • Level 2
  • 2293 Views
  • 11 replies
  • 0 Helpful votes

Hi,I just started to get the below error (on a Pop-up Applet), when i try to launch IPS MC in CiscoWorks VMS.+++++++++++++++++++++++++++++++++You are not authorized to request the action associated with screenID: "/s510".+++++++++++++++++++++++++++++...

mnlatif by • Level 7
  • 875 Views
  • 2 replies
  • 0 Helpful votes

Hi,Could someone please post a location for some good examples on how to configure a site-to-site vpn using IOS routers, that provides for QoS / prioritization for Voice traffic. I have seen some in the past, but I am curious if new enhancements have...

bdedek by • Level 2
  • 2014 Views
  • 6 replies
  • 0 Helpful votes

Hi folksI'm trying to configure Qos via Security Device Manager (latest version)but SDM reports that QOS isn't available (same with IPS). I've tried the latest 12.4 AdvSecurity Image to no avail. Does anyone know if using the ADV IPservices or ADV En...

tim_weldon by • Community Member
  • 992 Views
  • 3 replies
  • 0 Helpful votes

I have a number of vlan interfaces up and running in a production environment on our PIX 535 failover firewall pair. I had set up an IP address and failover IP on the physical interface, which is totally unused. Since I mistakenly usedloopback range ...

phaddad by • Level 2
  • 487 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card