Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have 4 1130 AP which will be used with a 2106 Controller.1. I can have a AP successfully join the Controller when the AP is NOT connected directly to one of the Controller Ports. After configuring the static IP for the Access Point, I can also ...
Hi,Is it possible to run iBGP as the IGP in a DMVPN (instead of EIGRP\OSPF) ?I am testing a deployment scenario where the iBGP connection always fails after initially coming up (stays up for around 30 minutes. The spoke says that it did not get the B...
Hi,I have 1 3550 and 2 2950 switches connected using a GigaStack Cable using the below setup3550 (Gigastack to 2950-SW1 and 2950-SW2 using Port Gi0/2)2950-SW1 to 2950-SW2 using GigaStack(Ports Gi0/1 on both)I somehow cannot seem to configure a 802.1q...
Hi,How do you determine the HW limitation for 2800 Series routers ? I cannot seem to find any related docs for this.Would a 2811 Router be able to handle upton 4.5Mbps of WAN traffic (Using 3 WICs) ?Thanks,Naman
Thanks for the quick response.I can try to see, if we can upgrade.Output with manual trunking is pretty much the same. The trunks are still 'Not' formed. So even with Trunking manually enabled on all specific ports the the Interfaces remain in Non-Tr...
<<<<< Continuation From Previous Messages>>+++++++++++++++++++++++++++++++++++++++++++SW05_2950 (2950 Switch using Gi0/1- Connected to SW03_3550 and SW04_2950)======================interface GigabitEthernet0/1end=====================Name: Gi0/1Switc...
Hi,That is the problem. Why am I not seeing the interfaces operating in Trunking Mode (Even when they are forced to be)? This config works fine when not using GigaStack.3550 actually has both ISL and 802.1q and I configured it to use 802.1q to match ...
