Network Security

Hi!could u plz give me a usefull link that contains various config for various scenario.

hi everyone!is there a way to permit voip traffic in a pix access-lists? that is permit only udp/rtp even port numbers?

It's been my experience that iTunes streaming of Internet radio stations is being interrupted by our AIP-SSM-10 running in inline mode. There are no alerts generated for the source or destination IP addresses in question. As soon as I change the clas...

I am installing lms 2.2 on Win2k server.When the server is not plugged to the network the installation is fine. But when it is plugged to the network the daemon manager will not start after any shutdown.What could be the cause of this problem?

I would like to know the command how to remove the PDM from PIX 515. Thanks.au-syd-fw# sh versCisco PIX Firewall Version 6.3(4)Cisco PIX Device Manager Version 3.0(4)

Has anyone had success on creating a site-to-site vpn with a Pix 501 and a Linksys RV082? I am having an issue establishing a connection. State on the pix side says: MM_NO_STATE Both sides are setup for 3des/md5. pre-shared key. Any ideas?

question is same with the title

Plaese help me reset password on ASA-AIP-10-INC-K9 module.Thanks,

Hi everybody.I'm currently implementing cisco ASA5510 with AIP SSM10 module, the asa is configured for transparent mode and inline mode for the ips.the problem is, after i apply the asa everything seems to go smooth for a moment, but after that i've ...

i couldn't establish tunnel between VPN 3000 & cisco 2811 router. here config for 2811. pls suugest wht else to be done..!!!!!!!!!!!!!!crypto isakmp policy 1 encr 3des hash md5 authentication pre-share group 2crypto isakmp key cisco address xx.xx.xx....

I've found 3 other posts on this with no resolution, so I thought I'd ask again. I've set up 3 local time servers (MIT, UMass Boston) in the NTP list to synchronize the time on my VPN 3000 Concentrator. I continually get the "NTP time synchronization...

Hello,Is it free to upgrade PIX from version 6.3 to 7.x or do I have to pay for it?Regards,Ofir.

Is there anyway to shutdown the unused switchports on the 501? I have one uplinked to a larger switch, and would prefer to have the unused ports shutdown as an extra security measure.Thanks

The pix failover switching time is too long , why none cisco documents give the time.

How to do password recovery for an 'NM-CIDS" module? It is installed in a Cisco 2811 router.