Network Security

HelloDoes anyone have an input on this system?How much of maintenance and work does the system require for initial set up and once it is up and running for opACL and opSIG updates with Trend?TIA

does anybody know if vpn concentrator 3015 can forward multicast packets?and if yes in which way?

Hi thereOn the old pix we dont have any issue with 7912 ip phone so the moment you lift the handset immediately you will get the dial tone after we installed the new pix using v7.0, we felt ard 2 secs of delay before you will hear the dial tone, stra...

Hi,I am trying to using "Block ACLs" using IDS on a Cisco Router. After required configuration, I can see the IDS sensor logged into the router but no-preblock ACL gets configured. Thus also no Blocking occurs after the signature hit.There are no pre...

I get this warning when setting up site to site vpn using pdm 3.0 on pix 515 ver 6.3(4)[OK] isakmp key @############## address 66.45.80.156 netmask 255.255.255.255 no-xauth no-config-mode[OK] pdm location 10.128.174.128 255.255.255.224 outside[OK] pd...

We have an ASA5520 running V7.1(1).We are trying to set up the MAPI proxy feature for Outlook client connections to MS Exchange. In general, the WebVPN service is working OK, but we cannot connect Outlook via MAPI.Config:group-policy testvpn attribut...

Below is a config that appears almost line per line similar to a working config (I removed SNMP, Telnet etc..). The first PIX runs just perfectly.The second which was being setting up this work has a few issues. First and foremost is the server at 19...

Hi,Could someone please post a location for some good examples on how to configure a site-to-site vpn using IOS routers, that provides for QoS / prioritization for Voice traffic. I have seen some in the past, but I am curious if new enhancements hav...

Hi folksI'm trying to configure Qos via Security Device Manager (latest version)but SDM reports that QOS isn't available (same with IPS). I've tried the latest 12.4 AdvSecurity Image to no avail. Does anyone know if using the ADV IPservices or ADV En...

I have a number of vlan interfaces up and running in a production environment on our PIX 535 failover firewall pair. I had set up an IP address and failover IP on the physical interface, which is totally unused. Since I mistakenly usedloopback rang...

I have 2 ASA5520s in failover mode, connected to a 3750 switch. The logs on the 3750 show the uplink interfaces to both ASAs going down/up occationally for 2 to 30 seconds. I didn't have logging on on the ASA at the time.Are there any known issues ...

I want to have link redundancy from each PIX to switches, too. is this possible?

Hi all,I'm trying to configure Guest access to internet through PIX506E. I would like to make a disclaimer banner for users so that when they try to access the internet, this disclaimer banner appears on their internet brower first and once they acce...