Network Security

I have a PIX 515E that has been running fine for awhle. However for the past few days we have been unable to reach an FTP site. when behind the PIX. If move outside the PIX can reach FTP site with no problem. The site is ftp.software.ibm.com/software...

I am replacing a software firewall with a PIX515E. I'm using the same inside and outside address's that are currently in place. I can ping to my inside router from the PIX, but no other traffic going through. I must be missing something. If someone c...

I have temporarily given access to my inside Exchange Server with 3 static commands.static (inside,outside) tcp 216.xxx.xxx.xxx smtp 10.10.10.9 smtp netmask 255.255.255.255 0 0static (inside,outside) tcp 216.x.x.x 443 10.10.10.9 443 netmask 255.255.2...

I am currently testing the TCP reset on our sensor but was not succesful. In cisco documentation TCP reset port of IDS-4250-SX is located in its sniffing port. My IDS is connected in a switch configured as to span traffic, will the TCP reset will be ...

Dear All, I have got a situation...The situation isthat I have a pix515e, Content Engine andCisco 2620xm router...The 3 attachments contain each of the systems configuration..They are arranged in the following way..There is a 192.168.0.0 network ID r...

Dear All Pro,I want to install and configure two numbers of IPS in load balancing config in the data center network. We will install 2 numbers of Cat 4507R in reduntant config.Pls suggest me the suitable configuration and installation and positioning...

Trying to set-up a ipsec lan to lan tunnel and need help with a nat lan to lan rule. It will be static nat, but im confused at what ip's go in source network, translated network, and remote network. The remote headend device is x.x.165.3, the source ...

Hi all,It is not clear to me on how to use "mask" and "flags" while editing a signature on IDM. In the wizad, I have the option to select the TCP flags to either fire (TRUE)or NOT to fire (FALSE) the alarm or ignore (Don't Care)the flag. Can someone ...

On atempting to access the pix manager I get a dialog box with "Host mismatch" after confirming yes to any certificates.. Any ideas please? This has happened after several microsoft updates on server2003 ans the addition of DMZ hardware

Does anybody know how to make a Linkys RV042 authenticate to a CISCO pix 506e's VPN tunnel?

we just upgrading pix 515E 64/16 mb from Version 6.3(4) to 7.0(1).during first booting messages appear:Initializing flashfs...flashfs[7]: Checking block 0...block number was (2423)---omitted----flashfs[7]: Checking block 120...block number was (0)fla...

I have a question about port settings. We recently have started to upgrade our backbone for future VOIP project. After the upgrade to a 4506 switch, Ive had nothng but errors is my pix syslog in regards to it interfacing with my Websense server. Both...

I had set up an interim pix that supported an AS/400 HTTPS applcaition to a remote site. No changed were made to the PIX other and setting up PPPoE. It worked from the start!!!How we are replacing the PIX with a 2811 running 12.3(8)T8. I have attache...

Easy question hopefully. From a Pix 525 version 7.0 (1). there is a 330 or 360 Mbps bandwidth limitation. Is this limitation applicable to trafffic going from the inside interface to an external external interface assuming it is not inspected ?

HiI'd like to know how this works. You pass the required exams, do you actually get recognized for having the InfoSec Cert?