Network Security

My network setup consists of a PIX firewall connected to a switched network with the PIX in turn connected to an Internet router. The PIX is used to for both web browsing and for termination of a handful of VPN tunnels with IOS routers on the other e...

I have been looking at using QoS to cut down on user web browsing traffic and downloading by assigning bandwidth and queue priority guarantees to more important traffic and therefore "starving" the bad traffic of bandwidth. However, it seems that mos...

I need to set up a P-2-P tunnel between a business client and my company. We attempted this today, we got past phase 2 but could not pass traffic. Here is they way I need to have it configured.3005 A) NAT/PAT We need to appear as one address. I creat...

How to configure PIX such that it redirect incoming http traffic to a internal proxy server?Thanks.

I have a Netscreen25 and a PIX 501 with an unusual setup. Here's how it looks.-Internet | Cisco 2600 Outside routable address | Inside address 10.0.0.1 | Netscreen Outside address Port 1 10.0.0.2 | Port 3 Inside address 192.168.1.1 | to 192.168.1.x |...

I have a question regarding my PIX 515.I am trying to find a way to allow users on the outside to access their computers here at the office via PcAnywhere through the PIX.Prior to buying this firewall, we had a NAT config set up on our 2610 router, a...

I have a Cisco PIX 506e securing a small network. It has been working fine allowing internet access for my users and VPN traffic apart from a very strange fault has occured over the last couple of days whereby some users on the network have internet ...

I use the logging to a syslog server(logging trap 2),168.168.44.1 is the ip address of pix(in the subnet,there are 3 unix server & about 5-6 windows workstation):2003-08-25 11:28:33 local4.critical 168.168.44.1 %pix-2-106016: deny ip spoof from (0.0....

I am attempting to find some type of chart that compares the features and limitations of installing a IOS based firewall compared to an actual PIX.I have searched the Cisco web site, and have come up empty.Thanks in advance.

Once I turn on ip audit name XXX infor and ip audit name action with drop option, I can't ping my firewall, or devices behind it any more. That is fine. However, I created an ACL to allow these ICMPs to go through, but they get dropped regardless of ...

This is the pIX515 current config for the remote access vpn using client 4.02a. I am not able to make the vpn connection to the headend device. **************pix_config***********access-list vpn_clients permit ip 192.168.0.0 255.255.255.0 192.168.1.7...

hi, I have following configuration on the pix 515nameif ethernet0 outside security0nameif ethernet1 inside security100nameif ethernet2 test 75nameif ethernet3 med security40From med to test, we need set up the outside nat to nat the med's IP became o...

How can I list the licenses on a PIX 520 ?