Network Security

I have routing problem on internal interface with pix firewall (O.S.version 6.1.4).

I wish to upgrade a PIX501 from 6.2 to 6.3 to enable remote management (SSH etc) via IPSEC VPN.The problem I've encountered is that the PIX 501 won't seem to communicate to/from a TFTP server on the inside network.I've tried:wr netcopy tftp flashtftp...

We recently changed ISP and as a result had to change our IP addresses.I made a note of the old addresses on the config and changed them to the new addresses this evening.We can connect to the Internet, and the VPN clients connect to the PIX, but we ...

I have a quick question, i have a LAN to LAN tunnel setup between two PIXs, if i setup telnet for the other side of the network, can i telnet to the internal interface of the other side of the PIXnetwork A-----PIX A--------VPN Tunnel--------PIX B----...

Scenario:To pix firewall's DMZ interface is a 3600 series router connected and to outside interface is one more router(3com or cisco) connecting to the internet . Solutions required :Currently i am accessing internet through outside router . Now i wa...

New in version 6.3 is the route-map command for use with OSPF. Does anyone know if it can be used to policy route based on static routes.Here is what I want to do.Outside ISP 1 ------- PIX Outside InterfaceOutside ISP 2 ------- PIX DMZ InterfaceInsid...

Hello, I want to confirm that it is not possible (with the default config) to get inside clients (static and natted) to make a PPTP connection through the PIX? Is this correct? I know that 6.3.1 supports the pptp fixup prot, but I am very hesitant on...

Is it possible, with VPN 3030, to configure the 3rd interface (which is labeled as "External" and, is usually used for "management", I assume) as another Public interface? So that two different kinds of VPN connections can be physically separated.......

I have a branch office setup with a site to site VPN through a Pix firewall. That branch office also has contracted with a third party to use Winfax Pro to fax through their server. The branch office can fax out to the internet but can not recieve an...

May anyone tell me how to know if my PIX 515E is Restricted or Unrestricted? The software version is 6.1(4), max interfaces is 6 and failover is enabled (info got from "sh version command" )Thx and best regards,Rafa.

We have a location that has a new Internet Circuit installed and a new PIX 515E. The site had pre-existing HP PRocurve 8000M switches installed without VLAN setup, Spanning Tree was setup. The PIX firewall is utilizing 3 ethernet ports (Inside, Outsi...

Is it possible to terminate a PPTP on a PIX and then assigned an IP from a pool configured on the PIX then be able to access the outside again through this IP, how can the routing of this scenario be configured on the PIX??? I know i am asking for so...

hi,is it possible to get the bgp neighbor description via snmp? running 12.0(21.1)Sthxmarkus

Can we give the IP address on outside and dmz interface like 10.10.1.2 and 10.10.1.3 respectively.Can we have the same subnet for the two interfaces.Any help would be appreciated.