Network Security

i have a Pix 515, and periodically the clients on the inside of the pix are unable to access the internet. If I reboot the router and do not touch the Pix all is ok. This problem started after we installed the Pix. Any ideas would be help, since we m...

Hello all.I have 1 ADSL router using its own NAT and PAT sitting between the ADSL point and E0. PC host on E1 unable to ping to the router on E0.Config of PIX as below:PIX Version 6.2(2)nameif ethernet0 outside security0nameif ethernet1 inside securi...

Hello,We recently migrated from an OpenBSD/PacketFilter firewall solution to a Pix 515E (6.2). In our previous setup, we used the firewall to redirect all port 80 requests to the proxy server in order to operate the proxy transparently. I have yet to...

Does anybody know from where I could find some information regarding the PIX version 6.3 new features (or currently developed ones) and approximate release date?

Hi, we have a VPN3030 with 3.5.5.Admin user is authenticated via TACACS. Is there any way to configure local authenticationfor admin user as backup if TACACS fails? Regards Guenther

I have a PIX 515. I am trying to do a show config on the box. It is giving me an error message saying"flash device is in use by another task". I do not know what this means or why it is being displayed. Pls help...thxKevin

On my NMS (Riversoft) we are getting this message, Trap:ClogMessageGenerated. Where can I find info on Trap messages for the pix 515? Also, what does this error mean? Thanks,

We have a pair of PIX 525 (v6.2.2) set up as a failover pair with Serial + crossover LAN failover cables providing the conversation between the two, and various other interfaces providing network connectivity (4FE, 2xGig). Whereas we believe this set...

I was reading how using DACL's can eliminate the need to have ACL configured on the PIX. My PIX uses ACL 's to make VPN tunnel end points for client networks. Can I use DACL's in conjunction with ACL Manager and a RADIUS server to keep the large ACL ...

I know that I can allow myselft access to my 6513 from the outside through the PIX, but my concern is, will this disrupt my routing occuring between my VLANs on the 6513? I would like to be able to SSH to my 6513 in case of emergencies if I am not on...

Hi, I have 2 problems with a PIX 501.First I need come back to the default configuration but the command "configure factory-default" doesn't work, then how can I do it?Second, I have a default route in the interface inside like route inside 0.0.0.0 0...

Can someone please tell me which entries in the CONFIG file represent the "VRRP Role" setting (Master, Backup1, etc....)?

Dear All,I would like to monitor the VPN3000 performance through HP Open View. I could find the MIB for CPU utilization, but couldn`t find the MIB for Memory usage. Already browsed the MIB Locator on CCO but couldn`t find anything. Does VPN3000 not h...

Can a global IP be the same as the outside interface IP? Can I just use one IP for both or do they need to be different?

Hello, I have suspiction (low performance), that my encryption aim is not running. If i type "show crypto engine accelerator brief" the output contains:" crypto engine name: unknown crypto engine type: ISA/ISM... crypto engine name: unknown crypto en...