Network Security

Hi, For some reasons i don't know a client wants absolutely to ping pix interfaces.I explain, from one interface of the pix he wants to ping through pix to to reach the other interface of the pix,Or through a network ping the interface of pix not in ...

Do Pix515UR come along with CSPM inbuilt or we have to separately order

I recently sold a Pix 501 firewall and need to install it. As far as I can see there should not be any problems. I would like to know it there would be a problem that I'm not aware of using this combination or if there's something I need to look out ...

hii would like to do VPN for a customer directly to the PIX without AAA serveur in this diagram it seems to be possible: http://www.cisco.com/warp/public/707/29.htmlcould i put different user and password for the VPN client thanks for your replyphili...

This seems like it SHOULD be a simple thing to do. Maybe I'm missing something obvious. After 9/11 we were forced to install another Internet access point at another location outside NYC. We basically duplicated what we had in NYC: Pix firewall on ou...

After upgrading the PIX 506 software to 6.11, and loading the PDM software (pdm-112.bin) I get an error: 'Not a PDM file'.Does someone has any idea how I get PDM on this PIX???(The PIX works OK with the 6.11 software)*PBY*

Hi ,I want that the IDS should apply an acl to PIX when it detects an attack.I have tested this and found that cspm(2.3.3i)says that it has applied the acl and also shows in the event viewer that the ip address is blocked.But when I see the access-li...

I have installed a third nic into my pix-520. Does the pix automatically recognize it? I tried the interface command, the results are below:interface ethernet2 autoCould not recognize hardware identifier "ethernet2"Boot messages are below:Rebooting.....

Hello, Is it true that you cannot NAT the ip address used by an interface on the PIX like you can on a cisco router ? We can only get one IP address from our isp. Can we still use a pix and NAT with only one ip ? Thanks!

I configured three vlans on catalyst2950,between 2950 and cisco3620,there is a pix 515,So could I make all of three vlans go to internet?If there is pix,i can configure subinterface on router,but now,how can i do?

Hi,I hope someone can help me.....I have a question here....I have installed CSPM233i and I have activaed the IDS feature in the PIX..and I have servers in the inside network... Can CSPM 233i send alert such as email if there is an attack to the serv...

I have a frame relay network that comes into the hub router into corporate HQ. We have a large SAP implementation that is hosted at a 3rd party location. So, traffic flows from the Frame, into the inside interface of the Corporate PIX 515, out the dm...

Is it possible to block .scr and other extensions at the Pix 515. Do I need additional software? Any examples would be greatly appreciated.Thanks,RJ

I have a frame relay network that comes into the hub router into corporate HQ. We have a large SAP implementation that is hosted at a 3rd party location. So, traffic flows from the Frame, into the inside interface of the Corporate PIX 515, out the dm...

Does anyone know when PPPoE support will be available for the Pix 501?