Hello,Can someone please tell me why I am unable to make changes to a text object and save it? I only see the close option as pictured when I should be seeing save and cancel as the options.Thank you in advance.
Forum Posts
Hi All,I am facing an issue with a Firepower NGFW 1120 connected to a PPPOE Connection. Some websites are loading very slow, for example office.com. The PPPOE connection has an MTU set to 1492 on vlan id 6. It looks like packets are not fragmented ri...
Hi everyone, We are seeing a warning alert on our corporate Firepower Management Center (FMC) that says: Realm – Domain Unrecognized (62%) This is currently being reported on both HA units: The message shows that 62% of the logins are from an unrecog...
Resolved! CSF 1210 CE FTD Event viewer problem
Good morning everyone,I noticed that on my CSF 1210 CE FTD, using the Firewall Device Manager, Monitoring - Event viewer section,events are received and displayed only if the page is open.It is not possible to view events that occurred when I am not ...
Hello there. Cisco FMC manages over 200 FTDs at Suncor. Is there a way i.e. commands or script to get the full list of chassis serial number of FTDs from FMC? Thanks.
Is there a way to setup a time range object to occur monthly instead of daily? I'm not currently seeing a way via the GUI. I'm thinking that this is a limitation, unless someone provides a way... Use case: allow access on the same day each month. ...
Resolved! Change Cipher Suites
I am using ASA-5516. I want to change the TLS1.2 ciphers to the following: ECDHE-RSA-AES256-GCM-SHA384DHE-RSA-AES256-GCM-SHA384ECDHE-RSA-AES128-GCM-SHA256DHE-RSA-AES128-GCM-SHA256 Can you help me with the commands or via ASDM?
Hello, I am sorry for posting this as it's similar to existing posts, but there seems to be massive confusion across the board with migrating the "perpetual" FS-VMW-10-SW-K9 license to the SF-FMC-VMW-10-K9. Most documentation notes that this pertains...
We are running 7.4.2-172 and these syslog ID's are missing and not available in the FMC. Is there a timeline when this is going to be resolved? We purchased Firemon and it needs to have these ID's for full functionality.
Resolved! about FTD-V
Does Cisco have a trial version? FTD-V-(20)S-BSE-K9，FTD-V-(20)S-TMC We will require the KVM version.
Hi All,We have 2 x 1Gbps Direct Connect between AWS and HA pair of FPR2140 (FMC managed) running FTD ver.7.4.2.1, BGP and ECMP to load balance the traffic. There are L2 switch in between them to split the single circuit to 2 firewalls.AWS's default k...
Hello Everyone,I have recently used cisco firepower 1120 for one of our customer, without any additional licenses. So as per my undertanding all the firepower comes with base license as perpetual. So, I proceed it with basic configuration, which give...
Hello dear communitywhen trying to migrate an ASA v9.18 to FTD managed by FMC using FMT v7.7 tools. i have the below message error:NoneType' object has no attribute 'cryptoMapNameEntry'we have no cryptomap configured on the existing firewall. any ide...
Resolved! Migration tool using a proxy
Dear community, I’m trying to use Cisco’s migration tool to migrate an ASA config to a FTD but I’m facing issues running it. Indeed, it tries to reach out cisco but it fails: 2023-12-28 14:35:21,125 [INFO | common] > "proxies : {}" 2023-12-28 14:3...
Is a Cisco firewall capable of microsegmentation? Can it handle east-west traffic and monitor traffic within the same VLAN?
