Network Security

 Configured an L2L VPN, but the ping fail.Can you see what's the problem??Please check the files 

I have a simple topology where two inside VLANS have HSRP Gateways needs to access Internet through ASA. I can ping the inside Interface of ASA 5506 (Packet Tracer Simulator) from PC/Laptop but cant able to ping the Internet Router. Can any one share...

Hello,I have been able to create the FlexConfig to configure EIGRP and it is working well with the FTD advertising and receiving routes.However I have a requirement to add a delay to an interface. When I try to add a delay via FlexConfig to an interf...

Good day I get a A secure connection to acs.rtt.co.za cannot be established.Normally, when you try to connect securely, sites will present trusted identification to prove that you are going to the right place. However, this site's identity can't be v...

HI, I have about few hundred FQDN objects. Which I have create on FMC. Is there any public script which can be used against FMC API to create them automatically?

I created a CSR on an ASA but when I received the certificate to install it I notiiced that the pending CSR was no longer visible in ASDM. I believe the CSR might actually still be saved on the ASA as I get a message when I try to recreate the CSR wi...

Hello, I have configured a destination NAT on the same incoming interface, but it does not works. Src 10.168.138.10DNS forwarder 172.21.2.100packet-tracer input Transito_Internet tcp 10.168.138.10 123 172.21.2.100Phase: 1Type: FLOW-LOOKUPSubtype:Resu...

I have a 5516 firewall with FDM and configure the DHCP on one of the sub-interface. now the device connected to that vlan is getting new and new IP after every 2 second. Kindly please help me in that. 

Hello everyone,   I am installing a FTD (5516-X)with FMC for a PoC to my customer.  I have configured a dhcp server on my inside interface. My 5516-X is linked with a switch in this interface, configured in access mode, vlan 2. I disabled dhcp snoopi...

Hello, Running ASA over Firepower/FXOS.Model - Firepower 2140TD Would like to know how can i back up running config or export-config file via CLI? Please someone help me. Thank you,Raju  

Hello,I need to configure the SRC and DST nat for The Active Directory domain needs to reach a DST nat to contact the external DNS Src 10.168.138.10DNS forwarder 172.21.2.130SNAT 194.169.30.1DNAT 8.8.8.8 This is my configuration. The interface incomi...

We have three FirePower 2130's running ASA software in appliance mode (a HA pair and a standalone unit).  We have configured SNMP on these with the command: snmp-server host management 10.1.1.1 community somecommunity version 2c IPv4 address & commun...

Hi, I Have a very odd/strange problem in relation to Access Control Security Policies on a FirePower 1010 managed using FDM. I'm configuring two Firepower 1010's with RA VPN and two very simple NAT rules to allow SMTP and FTP to two servers. I have a...