I have a simple issue.our customer has ASA 5508-FTD version 6.2.3.5 and they want to order an FMC license, which will be deployed on the cloud. So I want an appropriate FMC license, which must be compatible with FTD version 6.2.3.5.
Hello, Cisco ASA 5515-X blocks ip address even the ip address is within the same country i accpeted. As some of the community discussion i have seen & check the ip prefix in http://www.find-ip-address.org/ip-country/ . but initiator blocked ip is ...
Since I have never worked with ASA having a multiple WAN on same interface, how this can be achieved? My ISP has given me /29 IP address, and I assigned xxx.xxx.xxx.xxx/29 to one physical interface, set gw, route for gw, nat, access lists, etc. My qu...
Hello, does Cisco IOS Router/Switch supports 2FA without ISE / ACS / AD?? Thanks,Juan Carlos Arias
Hi, I've encountered a strange issue on one of my customers virtual FMC. When deploying configuration to a FTD 2100, there is no deployment or task status showing the progress of the deployment and when it's completed. The configuration is deployed w...
HiHope someone out there knows a solution, here goesSteps1. user opens a connection which travels across the site to site and hits a server at 3rd party2.the server then needs to reach inet to servers to authenticate the user3. so back across the si...
Hello, We bought Cisco NCS 5501-SE which is "Smart Enabled". I've generated a token in Cisco site for a device. Do i understand correctly that command: license smart register idtoken [token]and internet connection is enough for License to activate ?...
Hi All, Whether anyone tested time based ACL on Firepower ?Can we configured time based ACL on FTD via FMC. We are running v6.5. Regards,AKK
Seeking guidance on an ASA licensing concern. Currently a customer of mine has an RA VPN solution utilizing two 5555-X ASAs that are already paired in HA. New licenses were recently acquired and need to be installed. There has been back and forth wit...
I'm pretty sure the answer to this is no, but I'd like to check just in case there's a workaround. Is it possible for the management interface to be shared with the SFR module, so I can manage the ASA via SSH / ASDM via an IP on the management interf...
I am using Nexus 7710 switches on multiple networks and have updated the firmware on a some of the hardware already. The system file is n7700-s2-dk9.7.3.4.D1.1.bin & n7700-s2-kickstart.7.3.4.D1.1.bin is the kickstart file. I was recently informed the...
Hello!I'm using FTD 2110 managed by FMC. So I want working traceroute and made a threat defence policy with decrement ttl option like it described here.Traceroute starts working, but all connections (tcp, udp, icmp) after policy applying now has idle...
Hello, I have a Cisco ASA 5555 with a lot of working subinterface and I want to make a new subinterface but I can't.AHUFOT-KP-FW/CENTRAL/pri/act(config)# interface gigabitEthernet 0/4.196 ...
Hi Experts, Wanted to know about VxLAN configuration on Cisco-FTD. Also need information about deep-packet inspecting the VxLAN traffic. Does it require any additional configuration. A configuration document would be helpful. Thanks in advance!
I have cisco ASA 5510, and i want to apply 2 different access list say (access-list 100 & access-list 101) at same direction at same interfaceis it possible or not ??Thanks
