Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm going to renew my DNA for C9300 switches, but I see that I can only renew DNA through March 2025. I have read that after expiration the switch will continue to function, but I would lose Network Advantage rights. My license shows as perpetual t...
Hello,I have a route group in CUCM that refers to two difference CUBE routers. The service provider is providing an HA service, but the CUBE routers are not set up as an HA pair. They're two separate SIP trunks from the perspective of the Call Mana...
I'm attempting to set up dot1x authentication on a 3650 switch (just one port for now). I'm using NPS as my RADIUS server. I'm looking for help figuring out what this Missing Config mentioned in the debug is referring to. The debug on the switch sho...
I'm attempting to set up a new 8865 phone with one 28 button KEM (dual screen). The phone says it is unable to power the accessory.The phone is connected to a Cisco SG350-48MP. BWE-SW-02(config-if)#do show power inline gi1/0/25Interface Admin Oper P...
My Expressway logs show this event once per second:traffic_server[16496]: Event="Sending HTTP error response" Status="400" Reason="Bad Request" Dst-ip="127.0.0.1" Dst-port="30054" UTCTime="2020-10-15 15:59:52,083" I don't have any issues with how thi...
You can also continue to use your local license file, although CMM is still required to use it. Under licensing mode, choose traditional licensing. The cms.lic file is still in the CMS server as before.
I have upgrade the firmware on the switch to 2.5.5.47 and the issue seems to be resolved now. I was previously using version 2.5.0.83. It seems the renegotiation for more power was failing, but it is working now.05-May-2020 22:29:24 %NT_poe-I-PowerN...
set macro auto smartport on gi1/0/1 (but I don't see that config on the port)Power cycled the phone and the KEM is workingHTSLAB-SW-001#show run int gi1/0/1interface GigabitEthernet1/0/1switchport mode trunkvoice vlan enable!HTSLAB-SW-001#show power ...
