Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

How can I implement an ACL for the managed device IP of ASA 5525s with Firepower? I have deployed a pair of "ASA 5525 with Firepower" in Active/Standby mode. These devices are managed via FMC. The FMC uses these managed device IP to connect to FTD an...

Resolved! Firepower Sizing

Hello Experts, I need advice on the suggested models for Firepower based on the real world scenario. Unfortunately, i dont have access to any sizing tool. My requirements are to support throughput of 650 Mbps Internet link and would like to enable fe...

Hi I have 3 interfaces Inside (100)Outside (0)DMZ (50)I want to restrict traffic between DMZ and Inside, but as soon as i enter a outbound rule on DMZ to "any" i can communicate with the inside LAN. I only want to allow certain traffic through to cer...

hugradar by • Community Member
  • 1577 Views
  • 1 replies
  • 0 Helpful votes

I set up any connect on my ASA 5506-X, and my client can get connected by acquiring an internal IP address from the pool.  However, my client could not ping any internal resources (e.g. server).  Also my client could not connect to Internet.  The PIN...

 Firewall (N.G.F.) 01 Unit with 3-Year Warranty verifiable from Cisco:The proposed solution must support policy configuration modules for the 01 following functions from a single appliance• Fircwall Policies Min 10k or more, Concurrent Session 2.000....

i am having ASA firewall with 9.6 code. when i create and apply ACL as below it works fine ASA(config)#access-list abc permit icmp any any echo-replyASA(config)# access-group abc in interface Outside but when i wanna allow specific IP to ping to Outs...

Khurram by • Community Member
  • 5276 Views
  • 16 replies
  • 0 Helpful votes

In packet capture options when i mention the source or source and destination , packet capture buffer only displays the ingress interface traffic and it does not show any Egress interface traffic. Below i have attached the screenshot. what could be t...

jonk34567 by • Level 6
  • 2913 Views
  • 3 replies
  • 0 Helpful votes

Hi Guys,I am trying to enable some debug on an ASA5510 running 8.2(1) and want this debug sent to a syslog server in a test environment. My current config is below -logging enablelogging list test-ssh message 711001logging buffer-size 10000logging co...

ggr.support by • Frequent Visitor
  • 11795 Views
  • 12 replies
  • 0 Helpful votes