Network Security

Hello, I created a VPN connection between my ASA 5506 and AWS. According to AWS Support, everything is correct on the AWS side. It just continues this loop every hour. I've attached my config hoping that will help with troubleshooting. I can't start ...

Being these modules were unable to license signatures for a couple of years now, is there any use for the AIP-SSM-10 aside from a glorified paperweight? I did some cursory web searches, and I didn't find anything that would indicate a method to re-pu...

Hello techies, please I'm new to ASA and need some guidance here.- ASA 5106-x- Inside (security 100) to Outside (security 0) interface already NATed with first IP in ISP given range- I've connected a tiny unmanaged switch to a separate interface (sec...

Good morning, I’m doing some research on how to apply/implement STIG V-79449. The Requirement for my organization is to configure the network device to send an alert if its unable to generate or create logs. Any ideas on how this can be done?

dear all, I want to add AnyConnect to ASA 2100 series.Does anyone have a full documentation for me?Is the FPR2110-ASA-K9 still supported ? please help 

Hi Experts, I had given an task to implement the route in  Cisco ASA-55x0 device as below static (Data-DFS,inside) 10.176.92.66 10.176.25.218 netmask 255.255.255.255route Data-DFS 10.176.92.66 255.255.255.255 10.248.161.1 1 In this when I given quest...

 Is multicast still supported by VTI when it is configured between ASA and another security devices over a IKEv2VPN. Can anyone please provide me a simple configuration for transferring multicast traffic over vti between cisco asa and another devices...

I would like to access the users state in the ECE MRD for Chat (called Cisco_WIM, id 5004) user.getState() only works for the Voice MRD State user.getMediaState() only works in UCCX - I would like the UCCE equivalent.

Hi Team, I have cisco 7110 in mumbai  I need to recover an image on this appliance I tried the below link steps but no luck it does not help for me now it's showing the only system restore seral on boot no image able to see now. https://www.cisco.com...

Hello I am running into a wall with a problem.On one of my Interfaces on the 5508-X I have a Router connected which is using OpenVPN. On the Cisco under Access Rules I have a simple  " any any ip permit" and everything works like a charm. I wanted to...

Hello experts,While performing upgrade from ASA image(asa922-4-smp-k8  ) to FTD 6.4 , i encountered following messageErasing disk0 . . . Verifying 111Upgrade aborted.Ciscoasa-boot> ASA model  5525-X with FirePower services. First i upgraded the FTD b...

HI Team, I have cisco 7110 and 7030 on Chennai and Dehli  I unable to take GUI access and able to take console from connecting monitor but it's unable to login with default password can anyone help me out to get resolve from this problem iam attachin...

Hi, Can someone please  explain how to enable redundant interface on ASAv  on EVE-NG, I am facing a problem with ASAv getting an error while nameif command " ERROR: Failed to initialize interface INSIDE /ERROR: Add interface failed." thanks