I assume it's an ASA.
You would need the following commands to gain internet access.
We need to hairpin traffic for Anyconnect users.
same-security-traffic permit intra-interface
object network obj-AnyconnectPool
nat (outside,outside) dynamic interface
where obj-AnyconnectPool is the Anyconnect Pool network
TunnelAll means the traffic has to reach the headend (ASA) and from there we are routing the traffic (with the use of Dynamic PAT on the outside interface) to the internet.
You would need a reverse-route (for the pool) on the downstream device.
Something like this:
ip route x.x.x.x mask <ASA inside interface IP>
I am already using that NAT for inside access - how do allow the IP pool for AnyConnect to be allowed to the internet via the headend device.
The client connects to AnyConnect- receives and IP address from the AnyConnect IP pool.
with the NAT below they can reach internal networks but NOT the INTERNET. [I replaced the "any " with an internal object group.]
nat (inside,outside) source static any any destination static obj-Anyconnect obj-Anyconnect
What EXACTLY is needed to allow that AnyConnect IP pool to ALSO go to the internet? Because this NAT is not allowing the client out to the internet???
The following guide details all the steps you need to achieve this: https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/100918-asa-sslvpn-00.html
Please have a look and let us know if you have any questions.
I want to send audio material that I have on my computer to participants in my meetings. I want them to be able to listen to extracts that I select. Is this possible?
I need to create new VLAN02 for guest WIFI and set up some rules to restrict access to some IP address.
My ASA5506 is in BVI mode.
The current ASA interfaces are like this;
BVI1 – inside
GIG1/1 - outside -
GIG1/2 - inside_1 -
GIG1/3 - inside_2 -
GIG1/4 - inside_3 -
GIG1/5 - inside_4 -
GIG1/6 - inside_5 -
GIG1/7 - inside_6 -
GIG1/8 - inside_7 -
I want to assign GIG1/5 for VLAN02 as guest Wi-Fi and assign and IP address for this new VLAN.
What is the best practice to do it? Please.
Is it possible to demonstrate the setting from ASDM?