Configuring SSL Certificate on ASA 5520

[Wajma_2]

Hello,

I have a SSL certificate from a third party that is showing under the Identity in ADSM, howerver the audit scan of the firewall shows that the SSL Certificate Signed with an unknown certification Authority. I have installed the Intermediate Primary and Secondary Certificate from the third party under the CA Certificate of the ADSM however when I verify the SSL certificate it still shows as self-signed. What other steps do I miss. I have attached some screenshots.

Thank you for your assistance.

wo

[mirober2 · Accepted solution]

Hello,

Have you enabled the correct trustpoint under the Configuration > Device Management > Advanced > SSL Settings pane? On this screen, there is a section labeled "Certificates" where you can select the appropriate trustpoint for each interface.

The trustpoint will reference the certificate that you imported, and the interface will reference that trustpoint. Until you enable that, the ASA will continue to use its self-signed certificate.

Hope that helps.

-Mike

[Wajma_2]

Thank you for your help, it resolved the issue.

wo