05-18-2020 02:54 AM
Hi!
We have a firewall installed with the 6.5 track.
Exact FTD version is 6.5.0.4
FMC version is 6.5.0.4-57
I have patched with hotfix "Cisco_FTD_Hotfix_H-6.5.0.5-2"
FMC reports successful installation of hotfix, but in GUI it still says 6.5.0.4.
When I check CLI on FTD, it still says "Cisco ASA5516-X Threat Defense (75) Version 6.5.0.4 (Build 57)"
I can't find a command to verify that the hotfix is installed?
Regards
Johan
Solved! Go to Solution.
05-21-2020 06:18 AM
Go into expert mode on the sensor cli and run "rpm -qa"
05-18-2020 04:59 AM
To verify that your hotfix installed successfully, access the Linux shell (also called expert mode) and run the following command:
cat /etc/sf/patch_history
The system lists all successful major upgrades, patches, hotfixes, and pre-install packages since the appliance was freshly installed.
05-21-2020 06:02 AM
Hi Marvin,
this command only show FMC patch and version but it does not show FTD patch or Hotfix. recently i upgrdaed FTD with Patch 6.4.0.8 and also installed Hotfix 6.4.0.9 on FTD but i am not able to verify the Hotfix on FTD. when i run command cat /etc/sf/patch_history on FMC Cli then it shows only FMC related version and patch.
is there any way i can verify Hotfix on FTD Cli ?
Thanks in Advance
05-21-2020 06:18 AM
Go into expert mode on the sensor cli and run "rpm -qa"
05-21-2020 06:44 AM
Hi Marvin,
Thanks you very much, it realy worked.
i just entered Expert mode in FTD Cli.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide