03-24-2023 01:18 PM
I am setting up new FTD 1120 with local device manager.
I have a few queries.
a) When I issue the shutdown command as shown command from CLI (FW01(local-mgmt)# shutdown ) firewall reboots at the end. Is it normal?
b) When I login to the FTD for the first time as shown below, it prompts me to input the IP address. Is this IP address for MGMT interface ? FW01# connect ftd a
c) Under FTD mode too, there is shutdown command to shutdown the sensor. Is it mandatory to shutdown the sensor separately?
Solved! Go to Solution.
03-25-2023 02:12 AM
This is probably a bug CSCvy99348 Shutdown command reboots instead of shutting the FP1k device down. It has been fixed in 7.0.2, 7.0.4, 7.2.1 and above.
03-25-2023 02:27 AM
Maybe if the code you running that affecting the BUG? then yes you need to upgrade to a fixed version and test it.
Recently i installed a new FTD 3K Model - have a backside Switch (which it turns off the device) - that good i like it.
03-25-2023 01:50 AM
a) When I issue the shutdown command as shown command from CLI (FW01(local-mgmt)# shutdown ) firewall reboots at the end. Is it normal? - (yes its normal look at the below guide - Power Off the Device at the CLI)
b) When I login to the FTD for the first time as shown below, it prompts me to input the IP address. Is this IP address for MGMT interface ? FW01# connect ftd a - you need to setup basic config to connect to device- that is part of quick start guide
03-25-2023 01:58 AM
I have tried to issue shutdown from Console CLI, Web Console & SSH. In all 3 cases system reboots instead of shutdown.
03-25-2023 02:12 AM
This is probably a bug CSCvy99348 Shutdown command reboots instead of shutting the FP1k device down. It has been fixed in 7.0.2, 7.0.4, 7.2.1 and above.
03-25-2023 02:27 AM
Thank you.
I can shutdown from "connect local management" and as well as from "connect ftd a" mode. What is the difference between two?
03-25-2023 03:12 AM
I hope that both should behave identically, i.e. start graceful shutdown, when FTD application is shut down first, then other services are stopped. In general, "connect local-mgmt" mode is a leftover from bigger boxes (so to say), like FP4100/9300, where full-fledged FXOS system is implemented. On all Firepower systems this mode is used for troubleshooting, but the number of available commands varies. So, use "connect ftd" mode (connecting by IP will get you there automatically) or GUI.
03-25-2023 02:27 AM
Maybe if the code you running that affecting the BUG? then yes you need to upgrade to a fixed version and test it.
Recently i installed a new FTD 3K Model - have a backside Switch (which it turns off the device) - that good i like it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: