Firepower 7.0 very slow deployment speed

[swapsakker]

I just upgraded to Firepower 7.0. After upgrading the FMC the first deployment took about 30min on a 4100 firepower and about 25min on a 2100 firepower.
After upgrading the 2100 firepower, a standard deployment of a policy takes about 18min in total. but in the task it says 1.48min.
So what is happening in the 16min rest time ?

[#Mat]

Hi @swapsakker,
You're not alone. After the upgrade, I have the same behavior. I've FMCv, 2 FPR2110, and 1 FPR1120.

For new installations, deployments are completed in 1 ~ 2 min.

I'll try some more debugging and then go to TAC support.

Regards,

[swapsakker]

Great to konw that it is not my setup alone.

When i deploy, the deployment status says 5% for about 10min before it change to 8% and then is showen in taksk.

[p.lan]

Likewise, just upgraded FMC to 7.0 (keeping FTD 4110's on 6.7.0.2 for a bit). Very slow Deploy times now on the upgraded FMC that was on 6.7.0.2, and had 1-2min deploys before.

Any chance it's because the FTDs are on 6.7.x? Or is this the global experience on 7.0 FMC regardless of FTD version?

[swapsakker]

TAC is looking in to it.

[p.lan]

Were you able to find anything out on this case? 

I see 7.0.0.1 is out but cites no relevant fixes for slow deploys.

[swapsakker]

Hi

TAC i still working on it, and i hope we soon have a fix. 7.0.0.1 don't fix it. That is confirmed

[Eddie in.Mass]

Hello FMC/FTD users.....so i'm wondering what the status is of any TAC case(s) of this  'Slow Deployments after v7.0 FMC Update ' .... ain't nobody got time for a 25-35 min. process that used to take 2-3 minutes ....  Yikes ! 

[swapsakker]

By changing to Snort3 the deployment whent a lot faster, maby others could have the same luck.

Just be aware of possible internet problem.