FTD 2100 - Change Management Interface IP Address

[gamoore]

FTD 2110 initially setup for local FDM Management. Now, need to deploy FTD2110 with FMC Management and a new IP address. How do I change the Management IP address after the intial setup script has ran?

[Rahul Govindan · Accepted solution]

Since you have FDM access, I believe you should be able to change it from the FDM itself.

Via FTD CLI:

configure network ipv4 manual <mgmt0 IP> <netmask> <gateway> management0

"show network" should show you the management ip address.

[Salman.Baig]

Rahul Govindan  i configure the ip on ftd but i cant access ftd gui and also i cant ping able to the ftd 6.2.3 please help me what the problem is 

 Rahul Govindan

Member since 10-28-2015

 VIP Advocate 

    

See all badges

•  1420
•  1455
•  313

Send MessageView Profile

[vikachau]

 I am having the same problem -->>i configure the ip on ftd but i cant access ftd gui and also i cant ping able to the ftd 6.2.3 please help me what the problem is 

Please assist,

[imanv]

Thanks "Rahul Govindan",

But management0 at the end of this command is only for 4100 and 9300 series.

Don't use it on there models.

configure network ipv4 manual <mgmt0 IP> <netmask> <gateway> management0

Multiple management interfaces are supported on Firepower 4100 and 9300 series devices only. Do not specify this parameter
for other platforms. The management interface IDs on the Firepower 4100 and 9300 are management0 for the default management interface and management1 for the optional event interface.

Best Regards,