Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I wonder if anyone have had a similar issue as the one I have been experiencing, I have create a Trunk port with dual link for redundancy and added as Po66 by example.then created a sub interface with the IP 172.1.1.1/24 VLAN 66 zone: ...
Hello everyone,Happy Sunday to all! I am currently working on a production environment with dual ISPs, and I'm encountering some challenges with my configuration. I hope to get some guidance from the community.Network Setup:ISP 1: Interface 1/1 with ...
Hello everyone,I'm having trouble registering my FMC with Smart Licensing because it's on a segmented network with no direct internet access. I've added a secondary NIC (eth1) with internet connectivity, but I cannot find in the FMC's any interface ...
Hello guys,After a long battle with wsl I was able to made it run the FMC on a KVM machine in Ubuntu WSL however here is where my limits end, I cannot made pass network to the KVM on the management IP example: 192.168.2.2 and I have created a bridge ...
Hello guys,I ahve been trying to set a set of static intherphases to passthrough internet to the webservers. After setting my ISP inboud and 1/1 static interphase I am overlaping my network.overlapping network for ipv4 address: 10.10.10.1/27 on eth1/...
Thank you @Sheraz.Salim I appreciate the hint. The issue was indeed NAT, but it was more complex than initially thought due to my specific configuration. I'm handling a single public IP and can't route it to a /24 network. Therefore, I had to develop...
