12-13-2022 09:30 PM
Hello,
I'm trying to configure on a FPR-2140 appliance (FTD vers. 7.2.2) from FMCv (also running 7.2.2) equipped with a 4x SFP+ 10G NM etherchannels ports (LACP mode active) using using up to 4x 10G Interfaces.
This however do not seem to be working.
Generally speaking I can see a link up status (L1) (no ethernet activity from the FPR-2140 10 Gbit port itself though) as long as the port is not bundled - however as soon as I put the same interface into an Etherchannel Bond then is L1 connectivity completely gone.
Moreover, also simply configuring an IP address on the 10Gbit SFP+ Interface and using the Interface in Routed mode do not also seem to be working / possible.
I've read on the FPR 2100 documentation series that those 4x 10Gbit SFP+ Interfaces are meant to be used (mainly) for the Hardware Bypass solution; nevertheless I've also come across posts on this community where the 4x 10Gbit SFP+ interfaces could be configured using the ASA image - i.e.:
https://community.cisco.com/t5/network-security/it-is-necessary-license-for-use-sfp-10gb-in-ports-on-fpr4k/td-p/4391319
Am I hitting an FTD / FMC Limitation here ?
Do I need an extra License / different Firmware / FTD Image in order to be able to fully use those 10 Gbit SFP+ Ports ?
Is there a special configuration Procedure that I need to follow ?
Thank you for your help.
Best Regards
12-14-2022 12:10 AM
Hi - actually managed to solve the issue by myself - here the fix for future reference:
the 10G / SFP+ interfaces must be first enabled at fx-os level under the fabric scope; once enabled, it is possible to build / rollout LACP etherchannels from within FMC
Not 100% sure if this is a bug / limitation of the current FTD SW version or if it is so expected to work; nevertheless it would be definitely helpful to have it mentioned in the cisco configuration guides ...
12-15-2023 01:09 AM - edited 12-15-2023 01:10 AM
Hi Carlo, I have a similar issue, my switch reports no LACP on remote end when shut/no shut issued on the etherchannel connected ports, but FMC says FTD setup is correct. Do you have a more specific info on the FXOS config ? I have HA Pair of 2140's running v7.2.5 & the Primary 1st interface in port-channel is up, but second interface down/down on switch, same for both on Standby unit ! Been waiting days for TAC to come up with something useful
Thanks
Chris
12-15-2023 01:15 AM
Make new post
MHM
12-14-2022 12:22 AM
technically as per i know it support upto 16ports, what switch other side connected ? is the LACP come up or down all time ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide