A distribution-list is used to control routing update either coming to your router or leaving from the router. Distribution-lists work on a variety of different IOS routing protocols like EIGRP, RIP, and OSPF. Distribution-list is one of the easiest ways to control routing updates, you can permit or deny routes using access-list or prefix-list or route map. Distribution-list can be applied to transmitted, received, or redistribute routing updates.
Each interface and routing process, Cisco IOS permits the following:
Hi,I want to access a server using the public IP from the same internal network.Please the config belowip dhcp excluded-address 192.168.0.1 192.168.0.100
ip dhcp excluded-address 192.168.3.1
ip dhcp pool HOME
network 192.168.0.0 255.255.255.0
Team, I will have a Mellanox switch with a NVIDIA MMA1L30-CM Optical Transceiver 100GbE QSFP28 LC-LC 1310nm CWDM4 on one end of a 100GB SM fiber link and a Nexus N9K-C9336-C-FX2 with a QSFP-100G-SM-SR on the other end. Can someone tell me i...
Hi All, I have an SDA fabric using closed mode authentication and looking to setup a fabric site wide voice VLAN. I created a voice IP pool in the fabric and noticed that its not set as the default voice VLAN on my fabric edge ports (the default voic...
I'm trying to understand the difference between the device ID, system IP & local system IP that you get from a REST API poll of the device API? Can these be different and if so under what conditions? Thanks