(Live Webcast Tuesday December 11, 2018 at 10 am Pacific/ 1 pm Eastern / 7 pm Paris)
This event had place on Tuesday 11th, December 2018 at 10hrs PDT
In this event, you can learn more about the best network design practices. The session intends to introduce the attendees to network design, its roots and principles, and the mindset needed to be a successful designer and a holistic network architect. When it comes to network design, a solution is considered successful if it meets business requirements through technology implementation. Network designers are the bridge between technical and business domains. In this role, they must understand the business goals and be able to translate them into requirements that drive the technical implementation.
Network design principles
Network design mindset
Place all together, with examples and scenarios
David Samuel Peñaloza Seijas works as a Senior Network Consulting Engineer at Verizon Enterprise Solutions in the Czech Republic. Previously, he worked as a Network Support Specialist in the IBM Client Innovation Center in the Czech Republic. David is an expert interested in all topics related to networks. However, he focuses mainly on data centers, enterprise networks, and network design, including software-defined networking (SDN). David has a long relationship with Cisco. He has been a Cisco Instructor for the Cisco Academy and was recognized as a Cisco Champion and aCisco Designated VIPfor 2017 and 2018. David holds a CCNP R&S, CCDP, CCNA Security, CCNA CyberOps and a CCNA SP certification. Currently, he is preparing for a CCDE.
Hi, everyone!I have a simple ring topology with 10 nodes ( switches). I have two questions: 1-I think I can use multi-chassis LAG( link aggregation) instead of any spanning tree protocol, but I'm confused whether I'm able to use LACP instead of...
switchace5b2#28-Oct-2011 12:30:36 %VSDP-W-VSDPMD5AUTHFAILED: VSDP message from 10.10.10.10 was dropped, authentication is failed: key-string is ; key-id is 1., aggregated (2) What's the solutionThank you
Hi all, I understand bandwidth in QOS is use to guarantee a minimum bandwidthI understand police in QOS is to set a limit to the maximum bandwidth.class test_out
police 1608000 50000 100000 conform-action set-dscp-transmit af31 exceed-action set-ds...
I have VRF name TEST tied with Tunnel interface and this Tunnel using for DMVPN .
I used OSPF in same VRF as route protocol
I add one commands under OSPF 1 VRF TEST
The command was ”redestrubution eigrp 123 subnet” To test someth...
I tried to contact Cisco DNA to internet in order to but my Cisco CCO on it and to make the update the application on it.
Which port should be using for that? And from where config that? It is from DNA itself ?
I try to put the prox by name a...