Impossible to build ned: ignored file tailf-common-monitoring

[JM Montenot]

Hello All,

I am trying to build a netconf ned for a ISR4331 router but with no success so far.

I have downloaded the yang files from the device and performed a dependcy check (that is OK for the 266 yang files).

When I run the command build-netconf-ned command, it first starts saying:

Ignoring NCS-internal module "iana-crypt-hash.yang"

Ignoring NCS-internal module "ietf-netconf.yang"

Ignoring NCS-internal module "ietf-netconf-acm.yang"

Ignoring NCS-internal module "ietf-netconf-monitoring.yang"

Ignoring NCS-internal module "ietf-netconf-notifications.yang"

Ignoring NCS-internal module "ietf-netconf-with-defaults.yang"

Ignoring NCS-internal module "ietf-yang-smiv2.yang"

Ignoring NCS-internal module "tailf-acm.yang"

Ignoring NCS-internal module "tailf-common.yang"

Ignoring NCS-internal module "tailf-common-monitoring.yang"

Ignoring NCS-internal module "tailf-common-query.yang"

Ignoring NCS-internal module "tailf-netconf-inactive.yang"

Ignoring NCS-internal module "tailf-netconf-monitoring.yang"

Ignoring NCS-internal module "tailf-netconf-query.yang"

Ignoring NCS-internal module "tailf-netconf-transactions.yang"

Ignoring NCS-internal module "tailf-rest-error.yang"

Ignoring NCS-internal module "tailf-rest-query.yang"

Ignoring NCS-internal module "tailf-webui.yang"

Ignoring NCS-internal module "tailf-xsd-types.yang"

And then, ends up with an error saying: augmented/tailf-confd-monitoring@2013-06-14.yang:65: error: grouping 'live_ncs_common-monitoring-objects' in module 'tailf-common-monitoring' not found

Any tip to avoid ignoring the tailf files?

Thank you for your precious help.

EDIT1:

It seems that this issue comes from the fact that the ISR4331 embeds an IOS XE that offers four views (SNMP, Native, OpenConfig and IETF). Following Jan's advice in his post, I have chosen the Native view.

However, the file cisco-ia.yang seems broken, does this matter?

Thank you!

[Dan.Sullivan]

What version of NSO are you using?

-Dan

[Jan Lindblad · Accepted solution]

You need to disable cisco-ia.yang to make the NED work. It contains functionality to configure and work with the NETCONF subsystem, so nothing you'd normally have to touch for automation use cases.