03-12-2024 11:12 PM
In Cisco 9200L-24p can see that ports are connnected to PD (cameras)and power is allocated also..
port status is "not connected" and cameras aren't responding
03-13-2024 12:35 AM
Hello @jithinpnr ,
if commands like show interface x/y/z or show interface status show your port as not connected, then more than sure you have a cabling problem. Try with another patch cord.
Hope this helps.
03-13-2024 12:56 AM
Post the complete output to the following command:
sh power inline <PORT>
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide