- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-23-2005 03:09 AM
Hi All, I have two OSR-7609 connected through GE-WAN(OSM-4GE-WAN-GBIC). The traffic does not pass between them even though the interfaces in both the routers show up/up. Both routers are using IOS 12.1(20)E3. To initiate the traffice i need to give the command router#hw-module module <slot> reset command. Once the module comes online the routers start passing traffic. But it stops after 48 or 72 hrs in operation. Please help this Problem.
Regards
Arun
Solved! Go to Solution.
- Labels:
-
Optical Networking
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-27-2005 02:02 AM
hi arun
first ofall would suggest to go for a later ios ver like 12.2 instead of continuing with 12.1 and try ur luck.
if the problem still presists do raise a case with cisco TAC on this..
regds

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-27-2005 02:02 AM
hi arun
first ofall would suggest to go for a later ios ver like 12.2 instead of continuing with 12.1 and try ur luck.
if the problem still presists do raise a case with cisco TAC on this..
regds
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2005 03:59 AM
Prem, this is has been documented in bug CSCef12193 and CSCsa48615. You are right this device needs an upgrade.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2005 04:02 AM
Nandri Thalaiva.
