A CallManager, 6509 and RAS walk into a bar...

[adrianstuart]

Oh, If this were only a joke...

Here's what I have:

CCM 3.3.3r3

6509 running CatOS with 6608(Using 2PRIs 1 T1) , 10/100 (PWR), WS-X6182, SUPs and MSFC

RAS with own PRI used for dial out support only.

Here's what I am tring to do:

The PRI for the RAS is going away. I need to be able to integrate the RAS into the CCM/6509. By integrate I mean, plug the RAS into a port in the 6608 and it still be able to dial out. I need to know how to configure CCM to allow this to work. I know I will need a Crossover Cable on the PRI, but honestly I could use some feedback on this.

Adrian

[mcotrone]

I setup my customer recently to connect a PRI from the 6608 to the 3640 NM-1CT1 card. I established a route pattern to send the digits he wanted to this PRI. I configured the 3640 for asyn dial in to the MICA modem cards. To my surprise it works well.

Mike