Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was wondering if anyone had a similar problem with CME and UE.I can make a direct transfer to UE without any problems and I can see output in the debug ccsip messages debug. (Press the messages key on an IP Phone)I then try to make a redirected tra...
I can sit on an IP phone and press the messages key or dial 999 to access UE no problem, but when I dial in from the PSTN into the PRI the IP phone rings no problem. My problem is when the "call-forward noan timeout" occurs to 999 the call gets dropp...
I have been trying to block 900 numbers to go out but I am matching the LD dial-peer when I am blocking the 900 dialpeer. Any Ideas how to get around this?!dial-peer cor custom name Local-PT name LD-PT name Block-PT!!dial-peer cor list Local-CSS memb...
I can't seem to find out how to translate inbound calls into CME from the H323 network. You can use translation rules on the ephone-dn but that is only applied to calls made from the ephones. I need to send digits to the CME, translate, and then pass...
How are you forming your dial peers? Here is an idea of what you can do...dial-peer voice 10 potsdescription Dial-peer to PBXport x/ydestination-pattern 0664.......prefix 00664anddial-peer voice 20 potsport x/ydestination-pattern 812...prefix 0812Thi...
This usually is not an FXO issue, but a DTMF issue depending on the VOIP Signaling you are using (MGCP or H323).For MGCP verify you have:mgcp dtmf-relay voip codec all mode out-of-bandFor H.323 verify you have on the dial-peer:dial-peer voice 10 voip...
VIC2-DID can operate in one of two modes.1st if you have an analog DID circuit setup (similar to E&M wink/delay/immediate start) with the telco then you can use the VIC-2DID for inbound DID calls into the IP network only (Uni-directional). You can't ...
Tony,If I understand you correctly I would 8475552222 for the calling party transform mask on the individual lines. I would then take the transform mask off of the route-group and apply the 847555XXXX to the remaining phones using BAT. Is this an opt...
