Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
200
Views
0
Helpful
1
Replies

ATA 188 - no connectivity

tok
Level 1
Level 1

‎02-21-2005 10:26 AM - edited ‎03-13-2019 08:05 AM

Hi ! I'm setting up a ATA 188 in a demo lab - Version C3.1.0. ATASCCP - Build 040305B.

The device will not get a new config from the tftp server!!! I want to get SIP image on the device, but the upgrade fails both via TFTP or manual upgrade. I have configured the IP adresses via voice response and i have confirmede the IP adresses i'd put in - Stille I cannot ping or http to the device............... Any suggestions would be apreciated Thanx Tom

Labels:
0 Helpful
1 Reply 1

pradeepde
Level 5
Level 5

‎02-25-2005 10:09 AM

ATA allows you to configure static IP even when DHCP is configured. May be that is causing a problem in your case. Disable DHCP and try again.

To disable DHCP, go to the voice menu, press 20 and then press 0.

Note: Make sure that you save the configuration by pressing 3#.

See http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_qanda_item09186a00800946e1.shtml

There is a Q&A talking about this. I also found a TCC case written on this problem. Check out.

0 Helpful
Customers Also Viewed These Support Documents