Button script Cisco Touch 10

[Mbravo002]

Hello everyone. I have a problem configuring a button in the Cisco Touch 10. We need to create a StandBy button in the frontal page, but the script doesn´t recognize the elements and the parameters. Please if you can help us creating the script, or giving us the guide

Thanks a lot.

[Roger Kallberg · Accepted solution]

Start by posting your macro and screenshots of the UI configuration that you’ve done on the VC device. With this it will be much easier for us to give you help.

[Mbravo002]

thanks for your reply. I would like to know if there is any step by step, since the commands
that we have loaded do not work for us, also we would like
to know if it is also a problem with fiemware or something similar. Thank you

[Roger Kallberg]

Sorry but with the information that you have shared with us it’s not possible to provide you any assistance. Please at least share the version of the firmware that you use and the macro as it stands now. If you are not willing to share any details it’s not really meaningful to proceed with this.