04-29-2002 07:22 PM - edited 03-12-2019 06:37 PM
Hey everyone,
I have Call manager set up and two ip phone and one fxo wic for a 2600. I am trying to set the 2600 as the gateway for call manger so that the ip phones can make normal calls over the pots lines. Any input would be appreciated.
Drizzits
05-06-2002 11:00 AM
Often times complex configuration/troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
05-07-2002 12:38 AM
Setup the gateway as a gateway :-)).
And then make a routepattern for outgoing calls, pointing to the gateways IP.
i.e. let people dial 0 before the number, and let the routepattern match the 0.
/Rene Bo
Digiquant.com
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide