Callmanager H323 to Avaya Definity

[mike-reilly]

I am trying to configure an ip trunk between a callmanager 3.3 server and and avaya definity switch. I have created a h323 gateway in cm and a route pattern which goes out the cm to the avaya. I can make a call out this pattern from a phone registered to the cm to an avaya phone it rings two times then I get fast busy. Has anyone been able to get this up and running?

[kleo]

Yes..here you go:

http://www1.avaya.com/enterprise/applicationnotes/s8x00_ciscocm.pdf

[mike-reilly]

What version of callmanager did you use when you got this running? The version in this doc is 3.01, I am running 3.3?

[mike-reilly]

I am able to get calls to work from avaya to cm phone but calls from cisco to avaya are still having the same problem. This is the trace file any ideas:

10/28/2004 17:59:30.567 CCM|MediaManager - ERROR wait_AuConnectErrorInd|<:STANDALONECLUSTER><:10.69.96.226><:1><:><:>

10/28/2004 17:59:30.567 CCM|MediaManager - ERROR wait_AuConnectErrorInd - sending disconnect to 1 MediaExchanges|<:STANDALONECLUSTER><:10.69.96.226><:1><:><:>

10/28/2004 17:59:30.567 CCM|MediaManager - ERROR wait_AuConnectErrorInd - sending AuConnectErrorInd to parent|<:STANDALONECLUSTER><:10.69.96.226><:1><:><:>

10/28/2004 17:59:30.567 CCM|MediaManager - ERROR wait_AuConnectErrorInd - only (1) MediaExchange that reported error...going away.|<:STANDALONECLUSTER><:10.69.96.226><:1><:><:>

10/28/2004 17:59:30.567 CCM|MediaCoordinator -

[aalejo]

Yes, I did it. You need to use G711 and MTP because AVAYA does not understand empty capabilities set (for transfer and holding).

Alex