Can I enable SSH on cisco VG 202 system image is flash:vg20x-ipvoice-mz.124-22.T5.bin???? Thanks guys

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-08-2013 07:08 AM - edited 03-13-2019 08:22 PM
I am tryiing to roll out SSH V2 to each node in our estate which is capable of supporting it, is it possible to enable ssh v2 on the above VG????
- Labels:
-
Other Collaboration Topics

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-10-2013 10:48 AM
You will need a K9 image to enable SSH. The above image doesnt support it.
Please rate useful posts.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-11-2013 01:15 AM
Thanks George, can I ask, do you know if a VG 202 is capable of running a K9 image?

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-14-2013 11:25 AM
yes it is.
Please rate useful posts.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-15-2013 03:40 AM
Thanks again George! Could you recommend one? Or even better could you point me in the direction of somewhere I could learn what these devices are capable of supporting? I'm a relative newbie in my first job in Networking and have been charged with the job of rolling out SSH V2 to every device capable of supporting it within our estate. I was looking at this
http://pdfs.icecat.biz/pdf/23086081-2737.pdf data sheet and under protocols supported I can't see SSH?
Thanks again!
