Can SCCP & MGCP co-exists in Cisco 2600 router

[d-tay]

I have a cisco 2600 router wth a VWIC-1MFT-E1 port with AIM-VOICE-30 module for PSTN connection and a NM-HDV2 with PVDM2 DSP farm for hardware conferencing. I am using Cisco Call Manager ver 3.3 (4).

Can i configure MGCP for the PSTN connection and SCCP for the DSP conferencing resources for Call Manager 3.3 (4) or only H.323 and SCCP can be used for this situation.

Thanks

[jasyoung]

Yes, this is a supported configuration. There is no problem using MGCP and SCCP on the same router.

CallManager 3.3(4) service release 1a would be highly recommended. You'll also need very recent code on your router to support turning your NM-HDV2 into a conference bridge. Search Feature Navigator for the "Enhanced Conferencing and Transcoding for Voice Gateway Routers" feature. Feature Navigator can be found at:

http://www.cisco.com/go/fn

[d-tay]

Txs