CCM 4.1(2) and IP Phone Settings Access

[calmichael]

In CCM 4.1(2), at the phone level, the Settings

Access pull down shows Enabled, Disabled, and

Restricted.

If I select Restricted, click Update, and then

reset the IP Phone, the setting acts like it has

been set to Disabled, as items like being able to

change ringer volume, and other user items which

the Restricted setting should permit, are not

available.

Also, if I try and change from Restricted to

Disabled and then click update, the screen refresh

shows that Restricted is still selected.

But a change from Restricted to Enabled does work

as expected.

Has anyone else witnessed this issue, and if so

is there a mitigation for this issue?

Not exactly a P1/P2, but. . .

--- ----- ---

CCM 4.1(2) upgrade from 4.0(2)a, 2.6sr5,

7940/7960 P00307000200

[jmujica]

I'm having exactly the same problem. Did you found any solution?

-Jose

[calmichael]

I am waiting for the first service pack for this

code set. Our client's local Cisco SE had ran with

this and had found that this was documented and that

unless I wanted to go to the current ES, I should

wait for the first service pack which is due in Jan

to resolve this.

--- ----- ---