11-01-2014 11:43 AM - edited 03-13-2019 08:42 PM
We have Cisco DCM D9900 .Throught satellate we get channels with frequency ,polirization and etc.I know that need fill all channel parametries in DCM D9900.
I can`t understand where i can configure this parametries,and how i can get IP streaming video.
Do this DCM D 9900 series devices connects to MXE3500 ? How users can capture this IP streaming video ?
I have read some guides but didn`t understand anything.
Can someone describe step by step configuration ?
11-03-2014 09:53 PM
UP
11-05-2014 03:13 AM
Hi Emin,
First, which cards you have installed on DCM (GbE, ASI,DRD....)? If you want to join ip stream to DCM you'll need GbE card. GUI show left input side and right output side, you should right click to GbE card on left side and select settings, than IGMP and define which mcast want to join...
11-05-2014 07:03 AM
Hello ,
I have DVB-S2 cards in DCM.
How i can configure them with satellate parameters?
I have channels parameters but i can`t fill them in DVB-S2 card port configuration .
Can you give to me guide or example ?
11-07-2014 05:28 AM
Hi Emin,
the complete configuration guide is available on the DCM. Go to help/manuals on the GUI.
If you have issues during configuration, don t hesitate to open a service request. TAC will assist you.
11-05-2014 11:13 PM
Hello Milos,
I have configured DVB-S ports and it shows that locked ,Does it men that after configuring Gbe interfaces i will capture channels ?
Also i stay in stuck because of Gbe interfaces ,I have connected phisycally cable to Port 1 and Port 2.
But in my DCM it shows that Port 2 and Port 4 Streaming ,does it mean that i have to connect physical cabled to DCM`s Port 2 and Port 4 ,and after it i can capture images from Satellate
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide