Hello!
I just installed my first Callmanager cluster for a customer. Everything went fine, except the installation of the vg200. It took some time, until i found the right image to use(12.2.2(XM)). After using this image the configuration was very easy(ccm-manager config-download). :)
But now to my problem. If i start the vg200, using this configuration:
hostname mdhl-vg200-2
enable secret mdhl
interface FastEthernet0/0
ip address 172.17.12.6 255.255.254.0
duplex auto
speed auto
no shutdown
ip route 0.0.0.0 0.0.0.0 172.17.12.1
line vty 0 4
password mdhl
login
ccm-manager config server 172.17.12.9
ccm-manager config
, the vg200 is downloading it's configuration from the callmanager and is registering fine, with the primary callmanager. show ccm-manager looks fine and the callmanager is also saying, that this interface has registered.
After the download of the configfile, the vg200 save it's configuration as startup-config.
After next reboot, the vg200 is NOT able to register with a callmanager anymore! It's is still downloading it's configuration, show ccm-manager looks also fine(it says it is registered), but if i look at the status page in the callmanager, it says that it is not registered. And if the callmanager thinks, that the vg200 is not registred, i can't use it.
If i apply the configuration above again, its booting up, downloads its configuration and registers fine.
Does some seen something like this?
Any ideas?